On Thu, 2022-07-21 at 14:23 +0800, Slark Xiao wrote:
> Replace 'the the' with 'the' in the comment.
>
> Signed-off-by: Slark Xiao <slark_xiao@xxxxxxx>
Reviewed-by: Stuart Summers <stuart.summers@xxxxxxxxx>
> ---
> drivers/gpu/drm/display/drm_dp_helper.c | 2 +-
> drivers/gpu/drm/i915/i915_irq.c | 2 +-
> drivers/gpu/drm/panel/panel-novatek-nt35510.c | 2 +-
> 3 files changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/gpu/drm/display/drm_dp_helper.c
> b/drivers/gpu/drm/display/drm_dp_helper.c
> index e5bab236b3ae..32b295003f49 100644
> --- a/drivers/gpu/drm/display/drm_dp_helper.c
> +++ b/drivers/gpu/drm/display/drm_dp_helper.c
> @@ -1597,7 +1597,7 @@ static int drm_dp_aux_reply_duration(const
> struct drm_dp_aux_msg *msg)
>
> /*
> * Calculate the length of the i2c transfer in usec, assuming
> - * the i2c bus speed is as specified. Gives the the "worst"
> + * the i2c bus speed is as specified. Gives the "worst"
> * case estimate, ie. successful while as long as possible.
> * Doesn't account the "MOT" bit, and instead assumes each
> * message includes a START, ADDRESS and STOP. Neither does it
> diff --git a/drivers/gpu/drm/i915/i915_irq.c
> b/drivers/gpu/drm/i915/i915_irq.c
> index 73cebc6aa650..783a6ca41a61 100644
> --- a/drivers/gpu/drm/i915/i915_irq.c
> +++ b/drivers/gpu/drm/i915/i915_irq.c
> @@ -65,7 +65,7 @@
>
> /*
> * Interrupt statistic for PMU. Increments the counter only if the
> - * interrupt originated from the the GPU so interrupts from a device
> which
> + * interrupt originated from the GPU so interrupts from a device
> which
> * shares the interrupt line are not accounted.
> */
> static inline void pmu_irq_stats(struct drm_i915_private *i915,
> diff --git a/drivers/gpu/drm/panel/panel-novatek-nt35510.c
> b/drivers/gpu/drm/panel/panel-novatek-nt35510.c
> index 40ea41b0a5dd..4085822f619a 100644
> --- a/drivers/gpu/drm/panel/panel-novatek-nt35510.c
> +++ b/drivers/gpu/drm/panel/panel-novatek-nt35510.c
> @@ -231,7 +231,7 @@ struct nt35510_config {
> * bits 0..2 in the lower nibble controls HCK, the booster
> clock
> * frequency, the values are the same as for PCK in @bt1ctr.
> * bits 4..5 in the upper nibble controls BTH, the boosting
> - * amplification for the the step-up circuit.
> + * amplification for the step-up circuit.
> * 0 = AVDD + VDDB
> * 1 = AVDD - AVEE
> * 2 = AVDD - AVEE + VDDB
