Hi Andreas, Thanks for the comments. On 4/14/22 3:15 AM, Andreas Kemnade wrote: > Hi Samuel, > > for comparison, here is my submission for the IMX EPDC bindings: > > https://lore.kernel.org/linux-devicetree/20220206080016.796556-2-andreas@xxxxxxxxxxxx/ > > On Wed, 13 Apr 2022 17:19:02 -0500 > Samuel Holland <samuel@xxxxxxxxxxxx> wrote: > > [...] > we have sy7636a driver in kernel which should be suitable for powering a EPD > and temperature measurement. So I would expect that to be >> + io-channels: >> + maxItems: 1 >> + description: I/O channel for panel temperature measurement >> + > so how would I reference the hwmon/thermal(-zone) of the sy7636a here? It seems the consensus is to use a thermal zone for panel temperature, so I will need to change this. I think it's best to reference the thermal zone by phandle, not by name, even if it requires extending the thermal zone API to support this. >> + panel-supply: >> + description: Regulator supplying the panel's logic voltage >> + >> + power-domains: >> + maxItems: 1 >> + >> + vcom-supply: >> + description: Regulator supplying the panel's compensation voltage >> + >> + vdrive-supply: >> + description: Regulator supplying the panel's gate and source drivers >> + > SY7636a has only one logical regulator in kernel for for the latter two. Both properties could point to the same regulator node if there are more consumers than regulators. I don't know of a clean way to handle the opposite situation. The other benefit of separating out VCOM is that the controller or panel driver can set a calibrated voltage from e.g. NVMEM or the panel's DT node. > If we have a separate panel node, than maybe these regulators should go > there as they belong to the panel as they are powering the panel and > not the EBC. I agree on this. It doesn't work with panel-simple, but as Maxime points out, we have more flexibility with a custom panel driver. >> + port: >> + $ref: /schemas/graph.yaml#/properties/port >> + description: OF graph port for the attached display panel >> + > In my approach for the IMX EPDC, (I will send a better commented one > soon) I have no separate subnode to avoid messing with additional > display parameters. Not sure what is really better here. I tried to match the existing abstractions as much as possible, and I saw there was already an "eink,vb3300-kca" display in panel-simple. I believe that one was added for the reMarkable 2, where the existing LCD controller driver already depends on the DRM panel code (although I have concerns about hooking that up to a driver that doesn't understand EPDs). My thought here is that the timings for a given panel should be the same across controllers, both dedicated EPD controllers and LCD controllers. Or at least it should be possible to derive the timings from some common set of parameters. The panel node also usually hooks up to the backlight, although I am not sure that is the right thing to do for EPDs. (And the PineNote has a separate issue of having two backlights [warm/cool] for one display.) Regards, Samuel
