Kernel clock driver assumes that initial rate is the
max rate for that clock and was not allowing it to scale
beyond the assigned clock value.
Drop the assigned clock rate property and vote on the mdp clock as per
calculated value during the usecase.
Changes in v2:
- Remove assigned-clock-rate property and set mdp clk during resume sequence.
- Add fixes tag.
Changes in v3:
- Remove extra line after fixes tag.(Stephen Boyd)
Fixes: 62fbdce91("arm64: dts: qcom: sc7280: add display dt nodes")
Signed-off-by: Vinod Polimera <quic_vpolimer@xxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sc7280.dtsi | 9 ++-------
1 file changed, 2 insertions(+), 7 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sc7280.dtsi b/arch/arm64/boot/dts/qcom/sc7280.dtsi
index baf1653..408cf6c 100644
--- a/arch/arm64/boot/dts/qcom/sc7280.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7280.dtsi
@@ -2856,9 +2856,6 @@
"ahb",
"core";
- assigned-clocks = <&dispcc DISP_CC_MDSS_MDP_CLK>;
- assigned-clock-rates = <300000000>;
-
interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>;
interrupt-controller;
#interrupt-cells = <1>;
@@ -2892,11 +2889,9 @@
"lut",
"core",
"vsync";
- assigned-clocks = <&dispcc DISP_CC_MDSS_MDP_CLK>,
- <&dispcc DISP_CC_MDSS_VSYNC_CLK>,
+ assigned-clocks = <&dispcc DISP_CC_MDSS_VSYNC_CLK>,
<&dispcc DISP_CC_MDSS_AHB_CLK>;
- assigned-clock-rates = <300000000>,
- <19200000>,
+ assigned-clock-rates = <19200000>,
<19200000>;
operating-points-v2 = <&mdp_opp_table>;
power-domains = <&rpmhpd SC7280_CX>;
--
2.7.4
