Re: [PATCH] drm/msm/dpu: Bind pingpong block to intf on active ctls in cmd encoder

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 02/02/2022 12:48, Marijn Suijten wrote:
On 2022-01-20 02:12:51, Dmitry Baryshkov wrote:
On 22/12/2021 13:55, Marijn Suijten wrote:
As per the specification of DPU_CTL_ACTIVE_CFG the configuration of
active blocks should be proactively specified, and the pingpong block is
no different.

The downstream display driver [1] confirms this by also calling
bind_pingpong_blk on CTL_ACTIVE_CFG.  Note that this else-if is always
entered, as setup_intf_cfg - unlike this mainline dpu driver that
combines both behind the same function pointer - is left NULL in favour
of using setup_intf_cfg_v1 when CTL_ACTIVE_CFG is set.

This solves continuous timeouts on at least the Qualcomm sm6125 SoC:

      [drm:dpu_encoder_frame_done_timeout:2091] [dpu error]enc31 frame done timeout
      [drm:_dpu_encoder_phys_cmd_handle_ppdone_timeout.isra.0] *ERROR* id:31 pp:0 kickoff timeout 0 cnt 1 koff_cnt 1
      [drm:dpu_encoder_phys_cmd_prepare_for_kickoff] *ERROR* failed wait_for_idle: id:31 ret:-110 pp:0

In the same way this pingpong block should also be unbound followed by
an interface flush when the encoder is disabled, according to the
downstream display driver [2].

[1]: https://source.codeaurora.org/quic/la/platform/vendor/opensource/display-drivers/tree/msm/sde/sde_encoder_phys_cmd.c?h=LA.UM.9.16.r1-08500-MANNAR.0#n167
[2]: https://source.codeaurora.org/quic/la/platform/vendor/opensource/display-drivers/tree/msm/sde/sde_encoder.c?h=LA.UM.9.16.r1-08500-MANNAR.0#n2986

Signed-off-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxxx>

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>

---
   .../drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c  | 21 +++++++++++++++++++
   1 file changed, 21 insertions(+)

diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
index 8e433af7aea4..e0e08a874f07 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
@@ -71,6 +71,13 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg(
   	intf_cfg.stream_sel = cmd_enc->stream_sel;
   	intf_cfg.mode_3d = dpu_encoder_helper_get_3d_blend_mode(phys_enc);
   	ctl->ops.setup_intf_cfg(ctl, &intf_cfg);
+
+	/* setup which pp blk will connect to this intf */
+	if (test_bit(DPU_CTL_ACTIVE_CFG, &ctl->caps->features) && phys_enc->hw_intf->ops.bind_pingpong_blk)

Nit: here we bind all interfaces, but later we unbind only master. Is
this correct?

Not sure: it seems downstream only calls
_sde/dpu_encoder_phys_cmd_update_intf_cfg when it is _not_ a ppsplit
slave, which appears to be very similar to being the master (both check
for ENC_ROLE_SLAVE but ppsplit also checks RM topology support for
ppsplit).  Should we do this too before calling
_dpu_encoder_phys_cmd_update_intf_cfg?

The PP split is a special topology using a single LM, but two PP (and two INTFs). The dpu driver doesn't provide support for it, so ppsplit is always false.



- Marijn

+		phys_enc->hw_intf->ops.bind_pingpong_blk(
+				phys_enc->hw_intf,
+				true,
+				phys_enc->hw_pp->idx);
   }
static void dpu_encoder_phys_cmd_pp_tx_done_irq(void *arg, int irq_idx)
@@ -507,6 +514,7 @@ static void dpu_encoder_phys_cmd_disable(struct dpu_encoder_phys *phys_enc)
   {
   	struct dpu_encoder_phys_cmd *cmd_enc =
   		to_dpu_encoder_phys_cmd(phys_enc);
+	struct dpu_hw_ctl *ctl;
if (!phys_enc->hw_pp) {
   		DPU_ERROR("invalid encoder\n");
@@ -523,6 +531,19 @@ static void dpu_encoder_phys_cmd_disable(struct dpu_encoder_phys *phys_enc)
if (phys_enc->hw_pp->ops.enable_tearcheck)
   		phys_enc->hw_pp->ops.enable_tearcheck(phys_enc->hw_pp, false);
+
+	if (dpu_encoder_phys_cmd_is_master(phys_enc)) {

Please remove this condition. Just check for existence of bind_pingpong_blk.

+		if (phys_enc->hw_intf->ops.bind_pingpong_blk) {
+			phys_enc->hw_intf->ops.bind_pingpong_blk(
+					phys_enc->hw_intf,
+					false,
+					phys_enc->hw_pp->idx);
+
+			ctl = phys_enc->hw_ctl;
+			ctl->ops.update_pending_flush_intf(ctl, phys_enc->intf_idx);
+		}
+	}
+
   	phys_enc->enable_state = DPU_ENC_DISABLED;
   }


--
With best wishes
Dmitry


--
With best wishes
Dmitry



[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux