The mdp KMS driver will call drm_plane_create_zpos_property() with an init value depending on the plane purpose. Since the initial value wasn't carried over in the state, the driver had to set it again in mdp5_plane_reset(). However, the helpers have been adjusted to set it properly at reset, so this is not needed anymore. Cc: freedreno@xxxxxxxxxxxxxxxxxxxxx Cc: linux-arm-msm@xxxxxxxxxxxxxxx Cc: Abhinav Kumar <quic_abhinavk@xxxxxxxxxxx> Cc: Rob Clark <robdclark@xxxxxxxxx> Cc: Sean Paul <sean@xxxxxxxxxx> Signed-off-by: Maxime Ripard <maxime@xxxxxxxxxx> --- drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c | 7 ------- 1 file changed, 7 deletions(-) diff --git a/drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c b/drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c index d60982f4bd11..5d8ac84c510b 100644 --- a/drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c +++ b/drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c @@ -98,13 +98,6 @@ static void mdp5_plane_reset(struct drm_plane *plane) kfree(to_mdp5_plane_state(plane->state)); mdp5_state = kzalloc(sizeof(*mdp5_state), GFP_KERNEL); - - if (plane->type == DRM_PLANE_TYPE_PRIMARY) - mdp5_state->base.zpos = STAGE_BASE; - else - mdp5_state->base.zpos = STAGE0 + drm_plane_index(plane); - mdp5_state->base.normalized_zpos = mdp5_state->base.zpos; - __drm_atomic_helper_plane_reset(plane, &mdp5_state->base); } -- 2.34.1
