The ast driver supports different transmitter chips to support DVI and HDMI connectors. It's al been packed into the same helpers functons and exported as VGA connector. Introduce a separate set of connector helpers for each transmitter chip, and thus connector type. Also provide the correct encoder for each connector. This change mostly affects the connector's get_modes helper, where VGA-, DVI- and HDMI-related code was lumped into the same function. It's now all separate. While at it, also rework and cleanup the initialization of the related data structures. Tested on AST 2100 and AST 2300 hardware. I don't have hardware with special transmitter chips (SIL164, DP501), so I could only test the VGA code. Thomas Zimmermann (8): drm/ast: Fail if connector initialization fails drm/ast: Move connector mode_valid function to CRTC drm/ast: Remove AST_TX_ITE66121 constant drm/ast: Remove unused value dp501_maxclk drm/ast: Rename struct ast_connector to struct ast_vga_connector drm/ast: Initialize encoder and connector for VGA in helper function drm/ast: Move DP501-based connector code into separate helpers drm/ast: Move SIL164-based connector code into separate helpers drivers/gpu/drm/ast/ast_dp501.c | 58 ----- drivers/gpu/drm/ast/ast_drv.h | 37 ++- drivers/gpu/drm/ast/ast_mode.c | 413 +++++++++++++++++++++++--------- 3 files changed, 331 insertions(+), 177 deletions(-) base-commit: fbce7b8d8df5af8d404b6aeaf63779f91bdbeb5d prerequisite-patch-id: c2b2f08f0eccc9f5df0c0da49fa1d36267deb11d prerequisite-patch-id: c67e5d886a47b7d0266d81100837557fda34cb24 -- 2.34.1
