Re: [PATCH v2 06/11] drm/msm/disp/dpu1: Don't use DSC with mode_3d

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 25/10/2021 19:10, Vinod Koul wrote:
On 25-10-21, 17:40, Dmitry Baryshkov wrote:
On 20/10/2021 09:57, Vinod Koul wrote:
On 14-10-21, 16:50, Dmitry Baryshkov wrote:
On 14/10/2021 16:41, Dmitry Baryshkov wrote:
On 07/10/2021 10:08, Vinod Koul wrote:

diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.h
b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.h
index 806c171e5df2..5dfac5994bd4 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.h
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.h
@@ -39,6 +39,7 @@ struct dpu_hw_stage_cfg {
     * @mode_3d:               3d mux configuration
     * @merge_3d:              3d merge block used
     * @intf_mode_sel:         Interface mode, cmd / vid
+ * @dsc:                   DSC BIT masks
     * @stream_sel:            Stream selection for multi-stream interfaces
     */
    struct dpu_hw_intf_cfg {
@@ -46,6 +47,7 @@ struct dpu_hw_intf_cfg {
        enum dpu_3d_blend_mode mode_3d;
        enum dpu_merge_3d merge_3d;
        enum dpu_ctl_mode_sel intf_mode_sel;
+    unsigned int dsc;

I think this should be:
enum dpu_dsc dsc[MAX_DSCS];
unsigned int num_dsc;

hmmm, how do we go about getting the num_dsc value here.
dpu_encoder_phys does not know about that..

dpu_encoder_get_topology() can decide whether to use DSC or not and then set
num_dsc. For now it will always set 2 if we are using DSC at all, but let's
keep the decision in a single place rather than having it scattered all over
the driver.

Yes agree, but dpu_encoder_get_topology() is private to encoder. Am not
sure how best to propagate the info into the hw_intf_cfg?

Let dpu_encoder_get_topology() set num_dscs to 2 and merge_3d to 0 if the encoder has DSC information and to 0 otherwise. This will cover all topologies that we care about for now.

Regarding getting the DSC config. Currently you use single priv->dsc pointer, which works for the simple case of single DSI output, but will break as soon as somebody has DSC DSI + DP config. Either we can introduce the array of DSC configs, or we can add a DSI-specific msm_dsi_get_dsc_config(), which will be later paired with the corresponding displayport function.

--
With best wishes
Dmitry



[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux