Hi Dave, On Fri, Oct 8, 2021 at 9:32 PM Dave Stevenson <dave.stevenson@xxxxxxxxxxxxxxx> wrote: > > On Fri, 8 Oct 2021 at 14:37, Laurent Pinchart > <laurent.pinchart@xxxxxxxxxxxxxxxx> wrote: > > > > Hello, > > > > On Fri, Oct 08, 2021 at 03:27:43PM +0200, Andrzej Hajda wrote: > > > Hi, > > > > > > Removed my invalid email (I will update files next week). > > > > > > On 08.10.2021 13:14, Jagan Teki wrote: > > > > Hi, > > > > > > > > I think this seems to be a known use case for industrial these days with i.mx8m. > > > > > > > > The host DSI would configure with two bridges one for DSI to LVDS > > > > (SN65DSI83) and another for DSI to HDMI Out (ADV7535). Technically we > > > > can use only one bridge at a time as host DSI support single out port. > > > > So we can have two separate device tree files for LVDS and HDMI and > > > > load them static. > > > > > > > > But, one of the use cases is to support both of them in single dts, and > > > > - Turn On LVDS (default) > > > > - Turn Off LVDS then Turn On HDMI when cable plug-in > > > > > > Are you sure it will work from hardware PoV? Do you have some demuxer? > > > isolation of pins? > > > > It may be in the category of "you shouldn't do this, but it actually > > works". I've seen the same being done with two CSI-2 camera sensors > > connected to the same receiver, with one of them being held in reset at > > all times. > > Surely the correct way to do this would be with a D-PHY mux chip such > as OnSemi FSA642 [1] or those from Diodes Incorporated [2]. > How you'd integrate such a mux into DRM is a totally different question. > With V4L2 and CSI2 it'd be relatively simple via Media Controller. > > Just wiring them together isn't going to work very well for DSI > reverse direction communication, but neither of the chips Jagan lists > support this. Sorry to mention it before, we have two 2:1 MIPI D-PHY Switch [1] on the design which take 2 data-lanes and clock from Host and produce 4 data-lane and 1 clock to connect to ADV7535 and SN65DSI84 bridges. The switch has OE, SEL pins to select the desired to MUXed lanes/clock routing to an appropriate bridge. I think supporting the switch in the pipeline or logic that handle the bridge switching might help. [1] https://www.diodes.com/assets/Datasheets/PI3WVR626.pdf Jagan.
