On Fri, Jun 18, 2021 at 12:26 PM Colin Ian King
<colin.king@xxxxxxxxxxxxx> wrote:
>
> Hi,
Hi Colin
>
> Static analysis with Coverity has found a rather old issue in
> drivers/gpu/drm/gma500/oaktrail_crtc.c with the following commit:
Relevant code is in drivers/gpu/drm/gma500/oaktrail_lvds.c
>
> commit 9bd81acdb648509dbbc32d4da0477c9fae0d6a73
> Author: Patrik Jakobsson <patrik.r.jakobsson@xxxxxxxxx>
> Date: Mon Dec 19 21:41:33 2011 +0000
>
> gma500: Convert Oaktrail to work with new output handling
>
> The analysis is as follows:
>
> 114 /* Find the connector we're trying to set up */
> 115 list_for_each_entry(connector, &mode_config->connector_list,
> head) {
> 116 if (!connector->encoder || connector->encoder->crtc
> != crtc)
>
> Continue has no effect (NO_EFFECT)useless_continue: Statement
> continue does not have any effect.
>
> 117 continue;
> 118 }
> 119
> 120 if (!connector) {
> 121 DRM_ERROR("Couldn't find connector when setting mode");
> 122 gma_power_end(dev);
> 123 return;
> 124 }
>
> Currently it appears the loop just iterates to the end of the list
> without doing anything useful. I'm not sure what the original intent
> was, so I'm not sure how this should be fixed.
The code assumes there is only one correct connector so when iterating
over the connectors it checks for the connectors that does _not_ match
our criteria (!connector->encoder || connector->encoder->crtc
> != crtc). When the loop is done we end up with the correct connector set in the connector variable, hence the immediate check of "if (!connector) ...".
So the code is correct but perhaps unintuitive. You could do the
opposite (if that makes more sense to you):
list_for_each_entry(connector, &mode_config->connector_list, head) {
if (connector->encoder && connector->encoder->crtc == crtc)
break;
}
-Patrik
>
> Colin
