Instead of setting the variable and then using it just in the one place,
determine vco_delay directly at the PLL configuration time.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
Reviewed-by: Abhinav Kumar <abhinavk@xxxxxxxxxxxxxx>
Tested-by: Stephen Boyd <swboyd@xxxxxxxxxxxx> # on sc7180 lazor
---
drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c | 12 ++++--------
1 file changed, 4 insertions(+), 8 deletions(-)
diff --git a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c
index 3e9b7949b038..ed369eb18e9d 100644
--- a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c
+++ b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c
@@ -72,8 +72,6 @@ struct dsi_pll_28nm {
struct platform_device *pdev;
void __iomem *mmio;
- int vco_delay;
-
struct pll_28nm_cached_state cached_state;
};
@@ -212,8 +210,10 @@ static int dsi_pll_28nm_clk_set_rate(struct clk_hw *hw, unsigned long rate,
pll_write(base + REG_DSI_28nm_PHY_PLL_SDM_CFG4, 0x00);
/* Add hardware recommended delay for correct PLL configuration */
- if (pll_28nm->vco_delay)
- udelay(pll_28nm->vco_delay);
+ if (pll->cfg->quirks & DSI_PHY_28NM_QUIRK_PHY_LP)
+ udelay(1000);
+ else
+ udelay(1);
pll_write(base + REG_DSI_28nm_PHY_PLL_REFCLK_CFG, refclk_cfg);
pll_write(base + REG_DSI_28nm_PHY_PLL_PWRGEN_CFG, 0x00);
@@ -580,10 +580,6 @@ static int dsi_pll_28nm_init(struct msm_dsi_phy *phy)
pll = &pll_28nm->base;
pll->cfg = phy->cfg;
- if (phy->cfg->quirks & DSI_PHY_28NM_QUIRK_PHY_LP)
- pll_28nm->vco_delay = 1000;
- else
- pll_28nm->vco_delay = 1;
ret = pll_28nm_register(pll_28nm, phy->provided_clocks->hws);
if (ret) {
--
2.30.2
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
