Add DPI flag for distinguish MIPI input signal type, DSI or DPI. Add swing setting for adjusting DP tx PHY swing Signed-off-by: Xin Ji <xji@xxxxxxxxxxxxxxxx> --- .../bindings/display/bridge/analogix,anx7625.yaml | 25 ++++++++++++++++++++-- 1 file changed, 23 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/display/bridge/analogix,anx7625.yaml b/Documentation/devicetree/bindings/display/bridge/analogix,anx7625.yaml index 60585a4..4eb0ea3 100644 --- a/Documentation/devicetree/bindings/display/bridge/analogix,anx7625.yaml +++ b/Documentation/devicetree/bindings/display/bridge/analogix,anx7625.yaml @@ -34,6 +34,16 @@ properties: description: used for reset chip control, RESET_N pin B7. maxItems: 1 + analogix,swing-setting: + type: uint8-array + $ref: /schemas/types.yaml#/definitions/uint32-array + description: an array of swing register setting for DP tx PHY + + analogix,mipi-dpi-in: + type: int + $ref: /schemas/types.yaml#/definitions/uint32 + description: indicate the MIPI rx signal type is DPI or DSI + ports: type: object @@ -49,8 +59,8 @@ properties: Video port for panel or connector. required: - - port@0 - - port@1 + - port@0 + - port@1 required: - compatible @@ -72,6 +82,17 @@ examples: reg = <0x58>; enable-gpios = <&pio 45 GPIO_ACTIVE_HIGH>; reset-gpios = <&pio 73 GPIO_ACTIVE_HIGH>; + analogix,swing-setting = <0x00 0x14>, <0x01 0x54>, + <0x02 0x64>, <0x03 0x74>, <0x04 0x29>, + <0x05 0x7b>, <0x06 0x77>, <0x07 0x5b>, + <0x08 0x7f>, <0x0c 0x20>, <0x0d 0x60>, + <0x10 0x60>, <0x12 0x40>, <0x13 0x60>, + <0x14 0x14>, <0x15 0x54>, <0x16 0x64>, + <0x17 0x74>, <0x18 0x29>, <0x19 0x7b>, + <0x1a 0x77>, <0x1b 0x5b>, <0x1c 0x7f>, + <0x20 0x20>, <0x21 0x60>, <0x24 0x60>, + <0x26 0x40>, <0x27 0x60>; + analogix,mipi-dpi-in = <0>; ports { #address-cells = <1>; -- 2.7.4 _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel