PHY disable/enable resets PLL registers to default values. Thus in
addition to restoring several registers we also need to restore VCO rate
settings.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
Fixes: c6659785dfb3 ("drm/msm/dsi/pll: call vco set rate explicitly")
---
drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c | 8 ++++++++
1 file changed, 8 insertions(+)
diff --git a/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c b/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c
index 6ac04fc303f5..e4e9bf04b736 100644
--- a/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c
+++ b/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c
@@ -559,6 +559,7 @@ static int dsi_pll_10nm_restore_state(struct msm_dsi_pll *pll)
struct pll_10nm_cached_state *cached = &pll_10nm->cached_state;
void __iomem *phy_base = pll_10nm->phy_cmn_mmio;
u32 val;
+ int ret;
val = pll_read(pll_10nm->mmio + REG_DSI_10nm_PHY_PLL_PLL_OUTDIV_RATE);
val &= ~0x3;
@@ -573,6 +574,13 @@ static int dsi_pll_10nm_restore_state(struct msm_dsi_pll *pll)
val |= cached->pll_mux;
pll_write(phy_base + REG_DSI_10nm_PHY_CMN_CLK_CFG1, val);
+ ret = dsi_pll_10nm_vco_set_rate(&pll->clk_hw, pll_10nm->vco_current_rate, pll_10nm->vco_ref_clk_rate);
+ if (ret) {
+ DRM_DEV_ERROR(&pll_10nm->pdev->dev,
+ "restore vco rate failed. ret=%d\n", ret);
+ return ret;
+ }
+
DBG("DSI PLL%d", pll_10nm->id);
return 0;
--
2.28.0
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
