Hi, On Thu, Apr 09, 2020 at 04:01:30PM +0200, Sam Ravnborg wrote: > Hi Guido. > > On Thu, Apr 09, 2020 at 12:42:00PM +0200, Guido Günther wrote: > > This adds initial support for the NWL MIPI DSI Host controller found on i.MX8 > > SoCs. > > > > It adds support for the i.MX8MQ but the same IP core can also be found on e.g. > > i.MX8QXP. I added the necessary hooks to support other imx8 variants but since > > I only have imx8mq boards to test I omitted the platform data for other SoCs. > > > > The code is based on NXPs BSP so I added Robert Chiras as Co-authored-by. > > > > The most notable changes over the BSP driver are > > - Calculate HS mode timing from phy_configure_opts_mipi_dphy > > - Perform all clock setup via DT > > - Merge nwl-imx and nwl drivers > > - Add B0 silion revision quirk > > - become a bridge driver to hook into mxsfb / dcss > > imx-display-subsystem so it makes sense to make it drive a bridge for dsi as > > well). > > - Use panel_bridge to attach the panel > > - Use multiplex framework instead of accessing syscon directly > > > > This has been tested on a Librem 5 devkit using mxsfb with Robert's patches[1] > > and the mainline rocktech-jh057n00900 DSI panel driver on next-20200317 and on > > the Librem5 with the a Mantix MLAF057WE51-X DSI panel driver (not yet mainline) > > The DCSS (submitted for mainline inclusion now too) can also act as input > > source. > > Thanks for your persistence with this driver. > I got ack from Laurent on IRC to apply it (not for the driver as he had > no time to review it). > So applied to drm-misc-next now. > > I look forward for the update to support DRM_BRIDGE_ATTACH_NO_CONNECTOR > in this driver and the corresponding display driver. Thanks. I'll have a look at that (currently checking where the larger mxsfb rework of Laurent is going so i can use that as a base eventually). Cheers, -- Guido _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
