Re: [PATCH v3 1/4] drm/mediatek: Move tz_disabled from mtk_hdmi_phy to mtk_hdmi driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, 2020-04-02 at 20:49 +0800, Chun-Kuang Hu wrote:
> Hi, Matthias:
> 
> Matthias Brugger <matthias.bgg@xxxxxxxxx> 於 2020年4月1日 週三 下午11:53寫道:
> >
> >
> >
> > On 01/04/2020 04:16, Chunfeng Yun wrote:
> > > On Tue, 2020-03-31 at 23:57 +0800, Chun-Kuang Hu wrote:
> > >> From: CK Hu <ck.hu@xxxxxxxxxxxx>
> > >>
> > >> tz_disabled is used to control mtk_hdmi output signal, but this variable
> > >> is stored in mtk_hdmi_phy and mtk_hdmi_phy does not use it. So move
> > >> tz_disabled to mtk_hdmi where it's used.
> > >>
> > >> Signed-off-by: CK Hu <ck.hu@xxxxxxxxxxxx>
> > >> Signed-off-by: Chun-Kuang Hu <chunkuang.hu@xxxxxxxxxx>
> > >> ---
> > >>  drivers/gpu/drm/mediatek/mtk_hdmi.c           | 22 ++++++++++++++++---
> > >>  drivers/gpu/drm/mediatek/mtk_hdmi_phy.h       |  1 -
> > >>  .../gpu/drm/mediatek/mtk_mt2701_hdmi_phy.c    |  1 -
> > >>  3 files changed, 19 insertions(+), 5 deletions(-)
> > >>
> > >> diff --git a/drivers/gpu/drm/mediatek/mtk_hdmi.c b/drivers/gpu/drm/mediatek/mtk_hdmi.c
> > >> index 5e4a4dbda443..878433c09c9b 100644
> > >> --- a/drivers/gpu/drm/mediatek/mtk_hdmi.c
> > >> +++ b/drivers/gpu/drm/mediatek/mtk_hdmi.c
> > >> @@ -144,11 +144,16 @@ struct hdmi_audio_param {
> > >>      struct hdmi_codec_params codec_params;
> > >>  };
> > >>
> > >> +struct mtk_hdmi_conf {
> > >> +    bool tz_disabled;
> > >> +};
> > >> +
> > >>  struct mtk_hdmi {
> > >>      struct drm_bridge bridge;
> > >>      struct drm_bridge *next_bridge;
> > >>      struct drm_connector conn;
> > >>      struct device *dev;
> > >> +    const struct mtk_hdmi_conf *conf;
> > >>      struct phy *phy;
> > >>      struct device *cec_dev;
> > >>      struct i2c_adapter *ddc_adpt;
> > >> @@ -230,7 +235,6 @@ static void mtk_hdmi_hw_vid_black(struct mtk_hdmi *hdmi, bool black)
> > >>  static void mtk_hdmi_hw_make_reg_writable(struct mtk_hdmi *hdmi, bool enable)
> > >>  {
> > >>      struct arm_smccc_res res;
> > >> -    struct mtk_hdmi_phy *hdmi_phy = phy_get_drvdata(hdmi->phy);
> > >>
> > >>      /*
> > >>       * MT8173 HDMI hardware has an output control bit to enable/disable HDMI
> > >> @@ -238,7 +242,7 @@ static void mtk_hdmi_hw_make_reg_writable(struct mtk_hdmi *hdmi, bool enable)
> > >>       * The ARM trusted firmware provides an API for the HDMI driver to set
> > >>       * this control bit to enable HDMI output in supervisor mode.
> > >>       */
> > >> -    if (hdmi_phy->conf && hdmi_phy->conf->tz_disabled)
> > >> +    if (hdmi->conf->tz_disabled)
> >
> > Wouldn't we need to check:
> > if (hdmi->conf && hdmi->conf->tz_disabled)
> 
> My design is: hdmi->conf would not be NULL.
> 
> >
> > >>              regmap_update_bits(hdmi->sys_regmap,
> > >>                                 hdmi->sys_offset + HDMI_SYS_CFG20,
> > >>                                 0x80008005, enable ? 0x80000005 : 0x8000);
> > >> @@ -1688,6 +1692,7 @@ static int mtk_drm_hdmi_probe(struct platform_device *pdev)
> > >>              return -ENOMEM;
> > >>
> > >>      hdmi->dev = dev;
> > >> +    hdmi->conf = of_device_get_match_data(dev);
> > >>
> > >>      ret = mtk_hdmi_dt_parse_pdata(hdmi, pdev);
> > >>      if (ret)
> > >> @@ -1765,8 +1770,19 @@ static int mtk_hdmi_resume(struct device *dev)
> > >>  static SIMPLE_DEV_PM_OPS(mtk_hdmi_pm_ops,
> > >>                       mtk_hdmi_suspend, mtk_hdmi_resume);
> > >>
> > >> +static const struct mtk_hdmi_conf mtk_hdmi_conf_mt2701 = {
> > >> +    .tz_disabled = true,
> > >> +};
> > >> +
> > >> +static const struct mtk_hdmi_conf mtk_hdmi_conf_mt8173;
> > >> +
> > >>  static const struct of_device_id mtk_drm_hdmi_of_ids[] = {
> > >> -    { .compatible = "mediatek,mt8173-hdmi", },
> > >> +    { .compatible = "mediatek,mt2701-hdmi",
> > >> +      .data = &mtk_hdmi_conf_mt2701,
> > >> +    },
> > >> +    { .compatible = "mediatek,mt8173-hdmi",
> > >> +      .data = &mtk_hdmi_conf_mt8173,
> >
> > We don't have any data? Then we should set data to NULL instead.
> 
> My design is data would not be NULL, so I need not to check whether it
> is NULL in driver.
But we don't need .data for mt8173, it's better to set it to NULL.

> 
> Regards,
> CK
> 
> >
> > Regards,
> > Matthias
> >
> > >> +    },
> > >>      {}
> > >>  };
> > >>
> > >> diff --git a/drivers/gpu/drm/mediatek/mtk_hdmi_phy.h b/drivers/gpu/drm/mediatek/mtk_hdmi_phy.h
> > >> index 2d8b3182470d..fc1c2efd1128 100644
> > >> --- a/drivers/gpu/drm/mediatek/mtk_hdmi_phy.h
> > >> +++ b/drivers/gpu/drm/mediatek/mtk_hdmi_phy.h
> > >> @@ -20,7 +20,6 @@
> > >>  struct mtk_hdmi_phy;
> > >>
> > >>  struct mtk_hdmi_phy_conf {
> > >> -    bool tz_disabled;
> > >>      unsigned long flags;
> > >>      const struct clk_ops *hdmi_phy_clk_ops;
> > >>      void (*hdmi_phy_enable_tmds)(struct mtk_hdmi_phy *hdmi_phy);
> > >> diff --git a/drivers/gpu/drm/mediatek/mtk_mt2701_hdmi_phy.c b/drivers/gpu/drm/mediatek/mtk_mt2701_hdmi_phy.c
> > >> index d3cc4022e988..99fe05cd3598 100644
> > >> --- a/drivers/gpu/drm/mediatek/mtk_mt2701_hdmi_phy.c
> > >> +++ b/drivers/gpu/drm/mediatek/mtk_mt2701_hdmi_phy.c
> > >> @@ -237,7 +237,6 @@ static void mtk_hdmi_phy_disable_tmds(struct mtk_hdmi_phy *hdmi_phy)
> > >>  }
> > >>
> > >>  struct mtk_hdmi_phy_conf mtk_hdmi_phy_2701_conf = {
> > >> -    .tz_disabled = true,
> > >>      .flags = CLK_SET_RATE_GATE,
> > >>      .hdmi_phy_clk_ops = &mtk_hdmi_phy_pll_ops,
> > >>      .hdmi_phy_enable_tmds = mtk_hdmi_phy_enable_tmds,
> > >
> > > Reviewed-by: Chunfeng Yun <chunfeng.yun@xxxxxxxxxxxx>
> > >

_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel




[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux