On 2020-03-24 00:08, Stefan Agner wrote:
> On 2020-03-09 20:52, Laurent Pinchart wrote:
>> Enable vblank handling when the CRTC is turned on and disable it when it
>> is turned off. This requires moving vblank init after the KMS pipeline
>> initialisation, otherwise drm_vblank_init() gets called with 0 CRTCs.
>>
>> Signed-off-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>
>
> With this patch applied I start to get system resets on my Colibri iMX7
> test device during system boot shortly after initializing mxsfb. It
> happens not on every boot, but rather often, I would say every second or
> third. From what I can tell the interrupt handling should be safe, but
> it seems that every now and then something races. Any idea what that
> could be?
Disregard this: It seems that my power supply was a bit too weak which
lead to the system reset every now and then. With enough juice, I run
now quite some boots with the complete patchset applied without seeing
any issues.
Sorry about that.
--
Stefan
>
> --
> Stefan
>
>> ---
>> drivers/gpu/drm/mxsfb/mxsfb_drv.c | 15 +++++++++------
>> drivers/gpu/drm/mxsfb/mxsfb_kms.c | 6 +++++-
>> 2 files changed, 14 insertions(+), 7 deletions(-)
>>
>> diff --git a/drivers/gpu/drm/mxsfb/mxsfb_drv.c
>> b/drivers/gpu/drm/mxsfb/mxsfb_drv.c
>> index e324bd2a63a5..72b4f6a947a4 100644
>> --- a/drivers/gpu/drm/mxsfb/mxsfb_drv.c
>> +++ b/drivers/gpu/drm/mxsfb/mxsfb_drv.c
>> @@ -160,12 +160,6 @@ static int mxsfb_load(struct drm_device *drm,
>> unsigned long flags)
>>
>> pm_runtime_enable(drm->dev);
>>
>> - ret = drm_vblank_init(drm, drm->mode_config.num_crtc);
>> - if (ret < 0) {
>> - dev_err(drm->dev, "Failed to initialise vblank\n");
>> - goto err_vblank;
>> - }
>> -
>> /* Modeset init */
>> drm_mode_config_init(drm);
>>
>> @@ -175,6 +169,15 @@ static int mxsfb_load(struct drm_device *drm,
>> unsigned long flags)
>> goto err_vblank;
>> }
>>
>> + ret = drm_vblank_init(drm, drm->mode_config.num_crtc);
>> + if (ret < 0) {
>> + dev_err(drm->dev, "Failed to initialise vblank\n");
>> + goto err_vblank;
>> + }
>> +
>> + /* Start with vertical blanking interrupt reporting disabled. */
>> + drm_crtc_vblank_off(&mxsfb->crtc);
>> +
>> ret = mxsfb_attach_bridge(mxsfb);
>> if (ret) {
>> dev_err(drm->dev, "Cannot connect bridge: %d\n", ret);
>> diff --git a/drivers/gpu/drm/mxsfb/mxsfb_kms.c
>> b/drivers/gpu/drm/mxsfb/mxsfb_kms.c
>> index ac2696c8483d..640305fb1068 100644
>> --- a/drivers/gpu/drm/mxsfb/mxsfb_kms.c
>> +++ b/drivers/gpu/drm/mxsfb/mxsfb_kms.c
>> @@ -322,8 +322,10 @@ static void mxsfb_crtc_atomic_enable(struct drm_crtc *crtc,
>> dma_addr_t paddr;
>>
>> pm_runtime_get_sync(drm->dev);
>> -
>> mxsfb_enable_axi_clk(mxsfb);
>> +
>> + drm_crtc_vblank_on(crtc);
>> +
>> mxsfb_crtc_mode_set_nofb(mxsfb);
>>
>> /* Write cur_buf as well to avoid an initial corrupt frame */
>> @@ -353,6 +355,8 @@ static void mxsfb_crtc_atomic_disable(struct drm_crtc *crtc,
>> }
>> spin_unlock_irq(&drm->event_lock);
>>
>> + drm_crtc_vblank_off(crtc);
>> +
>> mxsfb_disable_axi_clk(mxsfb);
>> pm_runtime_put_sync(drm->dev);
>> }
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
