Hi All, I'm not sure if $subject was a conscious design decision, or an oversight, but that does not really matter. ATM the Atomic KMS API lacks the ability to set cursor hot-spot coordinates. Mutter (and Weston) have tried to emulate this by shifting the coordinates for where to draw the cursor by the hotspot-coordinates and always using 0x0 for the hotspot. But this breaks the so called "seamless mouse mode" for virtual-machines and there really is no way to fix this but to allow passing the proper hotspot coordinates to the virtual gfx-card. Seamless-mode consists of 2 parts: 1) Letting the VM-viewer window-system draw the cursor as it normally would draw it. 2) Giving absolute coordinates of the mouse to the VM by e.g. emulating an USB drawing tablet. These coordinates come from translating the coordinates where the VM-viewer window-system is drawing the cursor to an absolute position using the top left corner of the view as 0x0 and the bottom right corner as max-abs-x,max-abs-y. 2) Means that any coordinates the window-system inside the VM passes to the VM's gfx-card for where to draw the cursor are basically totally ignored to avoid lag / flicker (and to not have to grab the cursor / confine it to the VM-viewer window and to not have to warp the pointer). This means that the offset added to the coordinates by e.g. mutter to emulate the hotspot are ignored. For Seamless mouse mode to keep working properly the window-system inside the VM need to pass the VM's gfx-card the correct hotspot when setting the cursor. Which currently is not possible when restricting oneself to the atomic APIs. Also see: https://gitlab.gnome.org/GNOME/mutter/issues/1094 Where this is currently being tracked from the mutter side. Mutter internally has both atomic and legacy paths. The plan for now is to push the hotspot-emulation by shifting coordinates thing into the atomic path, fixing seamless mouse mode when running in legacy mode, combined with blacklisting vboxvideo, vmwgfx, qxl and cirrus from using atomic mode. This is of course a workaround, eventually we would like to see the atomic API extended to allow passing the cursor hot spot. I'm not really familiar enough with the atomic API to come up with an API design for this, but if there are suggestions on how this should look like from the uAPI side then I can take a shot at implementing this (and hooking it up in mutter's atomic code paths to test it). Regards, Hans p.s. Before people start discussing how the VM / VM-viewer is broken here and the VM needs to be fixed. Seamless mouse mode exists for at least a decade and has worked fine during this entire decade. It also works fine when using the legacy (non atomic) DRM_IOCTL_MODE_CURSOR2 ioctl; Also this problem reproduces with 2 completely independent VM code-bases, it has been seen on both qemu-kvm VMs and on VirtualBox VMs and I would not be surprised if other hypervisors are also affected. And on the API consumer side this problem has been triggered by both mutter and Weston. _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
