Hi Jitao.
On Fri, Feb 28, 2020 at 01:21:25PM +0800, Jitao Shi wrote:
> Add property "pinctrl-names" to swap pin mode between gpio and dpi mode. Set
> the dpi pins to gpio mode and output-low to avoid leakage current when dpi
> disabled.
>
> Signed-off-by: Jitao Shi <jitao.shi@xxxxxxxxxxxx>
> ---
> .../devicetree/bindings/display/mediatek/mediatek,dpi.txt | 7 +++++++
When this has landed it would be great if you could follow-up with a
conversion to DT Schema of this file (.yaml).
Sam
> 1 file changed, 7 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
> index 58914cf681b8..77ca32a32399 100644
> --- a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
> +++ b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
> @@ -17,6 +17,10 @@ Required properties:
> Documentation/devicetree/bindings/graph.txt. This port should be connected
> to the input port of an attached HDMI or LVDS encoder chip.
>
> +Optional properties:
> +- pinctrl-names: Contain "gpiomode" and "dpimode".
> + pinctrl-names see Documentation/devicetree/bindings/pinctrlpinctrl-bindings.txt
> +
> Example:
>
> dpi0: dpi@1401d000 {
> @@ -27,6 +31,9 @@ dpi0: dpi@1401d000 {
> <&mmsys CLK_MM_DPI_ENGINE>,
> <&apmixedsys CLK_APMIXED_TVDPLL>;
> clock-names = "pixel", "engine", "pll";
> + pinctrl-names = "active", "idle";
> + pinctrl-0 = <&dpi_pin_func>;
> + pinctrl-1 = <&dpi_pin_idle>;
>
> port {
> dpi0_out: endpoint {
> --
> 2.21.0
> _______________________________________________
> dri-devel mailing list
> dri-devel@xxxxxxxxxxxxxxxxxxxxx
> https://lists.freedesktop.org/mailman/listinfo/dri-devel
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
