Hi Maxime, On Fri, Feb 14, 2020 at 04:44:05PM +0100, Maxime Ripard wrote: > On Fri, Feb 14, 2020 at 03:10:25PM +0200, Laurent Pinchart wrote: > > On Fri, Feb 14, 2020 at 01:32:43PM +0100, Maxime Ripard wrote: > > > SoCs that have multiple TCONs can use the two set of pins on the first TCON > > > to drive a dual-link display. Add a property to enable the dual link. > > > > > > Signed-off-by: Maxime Ripard <maxime@xxxxxxxxxx> > > > --- > > > .../bindings/display/allwinner,sun4i-a10-tcon.yaml | 7 +++++++ > > > 1 file changed, 7 insertions(+) > > > > > > diff --git a/Documentation/devicetree/bindings/display/allwinner,sun4i-a10-tcon.yaml b/Documentation/devicetree/bindings/display/allwinner,sun4i-a10-tcon.yaml > > > index 86ad617d2327..aa6dd8409dbc 100644 > > > --- a/Documentation/devicetree/bindings/display/allwinner,sun4i-a10-tcon.yaml > > > +++ b/Documentation/devicetree/bindings/display/allwinner,sun4i-a10-tcon.yaml > > > @@ -105,6 +105,13 @@ properties: > > > - const: edp > > > - const: lvds > > > > > > + allwinner,lvds-dual-link: > > > + type: boolean > > > + description: | > > > + On a SoC with two TCON with LVDS support, the first TCON can > > > + operate over both pins sets to output in a dual-link setup. This > > > + will be triggered by setting this property. > > > > Could you maybe provide an example of how this property is supposed to > > be used ? I'm especially wondering what ports are used in that case and > > how they're connected. > > It's pretty trivial to support, it's only a property to set on the > encoder node itself. > > I'm not really sure what you meant by your question with the ports > though :/ I assume that, in the single-link case, you have two TCON instances that operate independently, each of them with one port that models an LVDS connection to a panel. In the dual-link mode, how does that look like ? Does the TCON instance that operate in dual-link mode have two ports in DT ? There are two physical ports, so I think it makes sense to always have two ports in DT. That's what we're doing for the LVDS encoders on R-Car Gen3, in order to specify in DT which LVDS input of the dual-link panel is connected to which LVDS output of the SoC. That allows configuring the LVDS encoder to send the even and odd pixels on the right port. -- Regards, Laurent Pinchart _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
