On Sat, Jan 18, 2020 at 3:11 AM Sam Ravnborg <sam@xxxxxxxxxxxx> wrote: > > Hi Rob. > > On Fri, Jan 17, 2020 at 05:17:56PM -0600, Rob Herring wrote: > > Convert all the 'simple' panels which match the constraints of the > > common panel-simple.yaml schema. This conversion is based on how the > > panels are documented. Some may turn out to be more complex once the > > schema is applied to actual dts files. > > Thanks for updating this patch - and very good to reduce the number of > files with almost the same content. > > One comment below, with that addressed: > Reviewed-by: Sam Ravnborg <sam@xxxxxxxxxxxx> > > There are likely some dt files that assume panels need no power and need a > fixed-regulator or something as power-supply now is mandatory. > Should this be checked before we apply this patch? Indeed there are, but we're not enforcing that schemas don't cause warnings yet. > As we continue to see new panels more or less every week I would like > this patch applied to drm-misc-next as soon as possible to avoid any > future conflicts. > > > index 513f03466aba..000000000000 > > --- a/Documentation/devicetree/bindings/display/panel/innolux,p120zdg-bf1.txt > > +++ /dev/null > > @@ -1,22 +0,0 @@ > > -Innolux P120ZDG-BF1 12.02 inch eDP 2K display panel > > - > > -This binding is compatible with the simple-panel binding, which is specified > > -in simple-panel.txt in this directory. > > - > > -Required properties: > > -- compatible: should be "innolux,p120zdg-bf1" > > -- power-supply: regulator to provide the supply voltage > > - > > -Optional properties: > > -- enable-gpios: GPIO pin to enable or disable the panel > > -- backlight: phandle of the backlight device attached to the panel > > -- no-hpd: If HPD isn't hooked up; add this property. > > panel-simple.yaml does not include the no-hpd property. > We only have 2 bindings, this and sharp,ld-d5116z01b.yaml > that include the no-hpd property. > > We have two options: > 1) add the no-hpd property to panel-simple.yaml > 2) keep an independent binding for panels using no-hpd > > I suggest to keep an independent binding for innolux,p120zdg-bf1 > so we keep panel-simple.yaml slim. > In other words do not delete this file and remove the compatible from > panel-simple.yaml Agreed. 'no-hpd' really only makes sense on eDP panels which have an a somewhat standard connector. Rob _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
