https://bugzilla.kernel.org/show_bug.cgi?id=201539 --- Comment #40 from MasterCATZ (mastercatz@xxxxxxxxxxx) --- aio@aio:~$ sudo pwmconfig [sudo] password for aio: # pwmconfig revision $Revision$ ($Date$) This program will search your sensors for pulse width modulation (pwm) controls, and test each one to see if it controls a fan on your motherboard. Note that many motherboards do not have pwm circuitry installed, even if your sensor chip supports pwm. We will attempt to briefly stop each fan using the pwm controls. The program will attempt to restore each fan to full speed after testing. However, it is ** very important ** that you physically verify that the fans have been to full speed after the program has completed. Found the following devices: hwmon0 is acpitz hwmon1 is amdgpu hwmon2 is coretemp hwmon3 is it8620 hwmon4 is it8792 Found the following PWM controls: hwmon1/pwm1 current value: 104 hwmon1/pwm1 is currently setup for automatic speed control. In general, automatic mode is preferred over manual mode, as it is more efficient and it reacts faster. Are you sure that you want to setup this output for manual control? (n) y hwmon1/pwm1_enable stuck to 2 Manual control mode not supported, skipping hwmon1/pwm1. -- You are receiving this mail because: You are watching the assignee of the bug. _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
