On Wed, Oct 09, 2019 at 02:34:54PM -0700, Jeffrey Hugo wrote: > On msm8998, vblank timeouts are observed because the DSI controller is not > reset properly, which ends up stalling the MDP. This is because the reset > logic is not correct per the hardware documentation. > > The documentation states that after asserting reset, software should wait > some time (no indication of how long), or poll the status register until it > returns 0 before deasserting reset. > > wmb() is insufficient for this purpose since it just ensures ordering, not > timing between writes. Since asserting and deasserting reset occurs on the > same register, ordering is already guaranteed by the architecture, making > the wmb extraneous. > > Since we would define a timeout for polling the status register to avoid a > possible infinite loop, lets just use a static delay of 20 ms, since 16.666 > ms is the time available to process one frame at 60 fps. > > Fixes: a689554ba6ed (drm/msm: Initial add DSI connector support) > Signed-off-by: Jeffrey Hugo <jeffrey.l.hugo@xxxxxxxxx> > --- > > Rob et al, is it possible for this to go into a 5.4-rc? > > drivers/gpu/drm/msm/dsi/dsi_host.c | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c > index 663ff9f4fac9..68ded9b4735d 100644 > --- a/drivers/gpu/drm/msm/dsi/dsi_host.c > +++ b/drivers/gpu/drm/msm/dsi/dsi_host.c > @@ -986,7 +986,7 @@ static void dsi_sw_reset(struct msm_dsi_host *msm_host) > wmb(); /* clocks need to be enabled before reset */ > > dsi_write(msm_host, REG_DSI_RESET, 1); > - wmb(); /* make sure reset happen */ > + msleep(20); /* make sure reset happen */ Could you please pull this out into a #define used for both in case we decide to tweak it? I don't want these 2 values to drift. Thanks, Sean > dsi_write(msm_host, REG_DSI_RESET, 0); > } > > @@ -1396,7 +1396,7 @@ static void dsi_sw_reset_restore(struct msm_dsi_host *msm_host) > > /* dsi controller can only be reset while clocks are running */ > dsi_write(msm_host, REG_DSI_RESET, 1); > - wmb(); /* make sure reset happen */ > + msleep(20); /* make sure reset happen */ > dsi_write(msm_host, REG_DSI_RESET, 0); > wmb(); /* controller out of reset */ > dsi_write(msm_host, REG_DSI_CTRL, data0); > -- > 2.17.1 > -- Sean Paul, Software Engineer, Google / Chromium OS _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
