Hi Artur, I tried to just build this patch on mainline kernel or linux-next. But, when I applied them, merge conflict happens. You didn't develop them on latest version. Please rebase them based on latest mainline kernel. On 19. 9. 20. 오전 10:07, Chanwoo Choi wrote: > Hi Artur, > > On v1, I mentioned that we need to discuss how to change > the v2 for this. But, I have not received any reply from you on v1. > And, without your reply from v1, you just send v2. > > I think that it is not proper development sequence. > I have spent many times to review your patches > and also I'll review your patches. You have to take care > the reply of reviewer and and keep the basic rule > of mailing contribution for discussion. > > On 19. 9. 19. 오후 11:22, Artur Świgoń wrote: >> The following patchset adds interconnect[1][2] framework support to the >> exynos-bus devfreq driver. Extending the devfreq driver with interconnect >> capabilities started as a response to the issue referenced in [3]. The >> patches can be subdivided into four logical groups: >> >> (a) Refactoring the existing devfreq driver in order to improve readability >> and accommodate for adding new code (patches 01--04/11). >> >> (b) Tweaking the interconnect framework to support the exynos-bus use case >> (patches 05--07/11). Exporting of_icc_get_from_provider() allows us to >> avoid hardcoding every single graph edge in the DT or driver source, and >> relaxing the requirement contained in that function removes the need to >> provide dummy node IDs in the DT. Adjusting the logic in >> apply_constraints() (drivers/interconnect/core.c) accounts for the fact >> that every bus is a separate entity and therefore a separate interconnect >> provider, albeit constituting a part of a larger hierarchy. >> >> (c) Implementing interconnect providers in the exynos-bus devfreq driver >> and adding required DT properties for one selected platform, namely >> Exynos4412 (patches 08--09/11). Due to the fact that this aims to be a >> generic driver for various Exynos SoCs, node IDs are generated dynamically >> rather than hardcoded. This has been determined to be a simpler approach, >> but depends on changes described in (b). >> >> (d) Implementing a sample interconnect consumer for exynos-mixer targeted >> at the issue referenced in [3], again with DT info only for Exynos4412 >> (patches 10--11/11). >> >> Integration of devfreq and interconnect functionalities is achieved by >> using dev_pm_qos_*() API[5]. All new code works equally well when >> CONFIG_INTERCONNECT is 'n' (as in exynos_defconfig) in which case all >> interconnect API functions are no-ops. >> >> This patchset depends on [5]. >> >> --- Changes since v1 [6]: >> * Rebase on [4] (coupled regulators). >> * Rebase on [5] (dev_pm_qos for devfreq). >> * Use dev_pm_qos_*() API[5] instead of overriding frequency in >> exynos_bus_target(). >> * Use IDR for node ID allocation. >> * Avoid goto in functions extracted in patches 01 & 02 (cf. patch 04). >> * Reverse order of multiplication and division in >> mixer_set_memory_bandwidth() (patch 11) to avoid integer overflow. >> >> --- >> Artur Świgoń >> Samsung R&D Institute Poland >> Samsung Electronics >> >> --- >> References: >> [1] Documentation/interconnect/interconnect.rst >> [2] Documentation/devicetree/bindings/interconnect/interconnect.txt >> [3] https://patchwork.kernel.org/patch/10861757/ (original issue) >> [4] https://patchwork.kernel.org/cover/11083663/ (coupled regulators; merged) >> [5] https://patchwork.kernel.org/cover/11149497/ (dev_pm_qos for devfreq) >> [6] https://patchwork.kernel.org/cover/11054417/ (v1 of this RFC) >> >> Artur Świgoń (10): >> devfreq: exynos-bus: Extract exynos_bus_profile_init() >> devfreq: exynos-bus: Extract exynos_bus_profile_init_passive() >> devfreq: exynos-bus: Change goto-based logic to if-else logic >> devfreq: exynos-bus: Clean up code >> interconnect: Export of_icc_get_from_provider() >> interconnect: Relax requirement in of_icc_get_from_provider() >> interconnect: Relax condition in apply_constraints() >> arm: dts: exynos: Add parents and #interconnect-cells to Exynos4412 >> devfreq: exynos-bus: Add interconnect functionality to exynos-bus >> arm: dts: exynos: Add interconnects to Exynos4412 mixer >> >> Marek Szyprowski (1): >> drm: exynos: mixer: Add interconnect support >> >> .../boot/dts/exynos4412-odroid-common.dtsi | 1 + >> arch/arm/boot/dts/exynos4412.dtsi | 10 + >> drivers/devfreq/exynos-bus.c | 319 +++++++++++++----- >> drivers/gpu/drm/exynos/exynos_mixer.c | 71 +++- >> drivers/interconnect/core.c | 12 +- >> include/linux/interconnect-provider.h | 6 + >> 6 files changed, 327 insertions(+), 92 deletions(-) >> > > -- Best Regards, Chanwoo Choi Samsung Electronics _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
