On 8/14/19 12:45 PM, Dariusz Marcinkiewicz wrote:
> Use the new cec_notifier_conn_(un)register() functions to
> (un)register the notifier for the HDMI connector, and fill
> in the cec_connector_info.
>
> Changes since v6:
> - move cec_notifier_conn_unregister to tda998x_bridge_detach,
> - add a mutex protecting accesses to a CEC notifier.
> Changes since v2:
> - cec_notifier_phys_addr_invalidate where appropriate,
> - don't check for NULL notifier before calling
> cec_notifier_conn_unregister.
> Changes since v1:
> Add memory barrier to make sure that the notifier
> becomes visible to the irq thread once it is
> fully constructed.
>
> Signed-off-by: Dariusz Marcinkiewicz <darekm@xxxxxxxxxx>
> ---
> drivers/gpu/drm/i2c/tda998x_drv.c | 36 +++++++++++++++++++++----------
> 1 file changed, 25 insertions(+), 11 deletions(-)
>
> diff --git a/drivers/gpu/drm/i2c/tda998x_drv.c b/drivers/gpu/drm/i2c/tda998x_drv.c
> index 61e042918a7fc..643480415473f 100644
> --- a/drivers/gpu/drm/i2c/tda998x_drv.c
> +++ b/drivers/gpu/drm/i2c/tda998x_drv.c
> @@ -82,6 +82,8 @@ struct tda998x_priv {
> u8 audio_port_enable[AUDIO_ROUTE_NUM];
> struct tda9950_glue cec_glue;
> struct gpio_desc *calib;
> +
> + struct mutex cec_notifiy_mutex;
> struct cec_notifier *cec_notify;
> };
>
> @@ -805,8 +807,11 @@ static irqreturn_t tda998x_irq_thread(int irq, void *data)
> tda998x_edid_delay_start(priv);
> } else {
> schedule_work(&priv->detect_work);
> - cec_notifier_set_phys_addr(priv->cec_notify,
> - CEC_PHYS_ADDR_INVALID);
> +
> + mutex_lock(&priv->cec_notifiy_mutex);
> + cec_notifier_phys_addr_invalidate(
> + priv->cec_notify);
> + mutex_unlock(&priv->cec_notifiy_mutex);
> }
>
> handled = true;
> @@ -1331,6 +1336,8 @@ static int tda998x_connector_init(struct tda998x_priv *priv,
> struct drm_device *drm)
> {
> struct drm_connector *connector = &priv->connector;
> + struct cec_connector_info conn_info;
> + struct cec_notifier *notifier;
> int ret;
>
> connector->interlace_allowed = 1;
> @@ -1347,6 +1354,16 @@ static int tda998x_connector_init(struct tda998x_priv *priv,
> if (ret)
> return ret;
>
> + cec_fill_conn_info_from_drm(&conn_info, connector);
> +
> + notifier = cec_notifier_conn_register(priv->cec_glue.parent,
> + NULL, &conn_info);
> + return -ENOMEM;
You dropped a 'if (!notifier)' before the return!
After adding back this 'if' it worked fine on my BeagleBone Black board,
so after fixing this you can add my:
Tested-by: Hans Verkuil <hverkuil-cisco@xxxxxxxxx>
tag.
Regards,
Hans
> +
> + mutex_lock(&priv->cec_notifiy_mutex);
> + priv->cec_notify = notifier;
> + mutex_unlock(&priv->cec_notifiy_mutex);
> +
> drm_connector_attach_encoder(&priv->connector,
> priv->bridge.encoder);
>
> @@ -1366,6 +1383,11 @@ static void tda998x_bridge_detach(struct drm_bridge *bridge)
> {
> struct tda998x_priv *priv = bridge_to_tda998x_priv(bridge);
>
> + mutex_lock(&priv->cec_notifiy_mutex);
> + cec_notifier_conn_unregister(priv->cec_notify);
> + priv->cec_notify = NULL;
> + mutex_unlock(&priv->cec_notifiy_mutex);
> +
> drm_connector_cleanup(&priv->connector);
> }
>
> @@ -1789,9 +1811,6 @@ static void tda998x_destroy(struct device *dev)
> cancel_work_sync(&priv->detect_work);
>
> i2c_unregister_device(priv->cec);
> -
> - if (priv->cec_notify)
> - cec_notifier_put(priv->cec_notify);
> }
>
> static int tda998x_create(struct device *dev)
> @@ -1812,6 +1831,7 @@ static int tda998x_create(struct device *dev)
> mutex_init(&priv->mutex); /* protect the page access */
> mutex_init(&priv->audio_mutex); /* protect access from audio thread */
> mutex_init(&priv->edid_mutex);
> + mutex_init(&priv->cec_notifiy_mutex);
> INIT_LIST_HEAD(&priv->bridge.list);
> init_waitqueue_head(&priv->edid_delay_waitq);
> timer_setup(&priv->edid_delay_timer, tda998x_edid_delay_done, 0);
> @@ -1916,12 +1936,6 @@ static int tda998x_create(struct device *dev)
> cec_write(priv, REG_CEC_RXSHPDINTENA, CEC_RXSHPDLEV_HPD);
> }
>
> - priv->cec_notify = cec_notifier_get(dev);
> - if (!priv->cec_notify) {
> - ret = -ENOMEM;
> - goto fail;
> - }
> -
> priv->cec_glue.parent = dev;
> priv->cec_glue.data = priv;
> priv->cec_glue.init = tda998x_cec_hook_init;
>
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
