On Sat, Aug 10, 2019 at 5:10 PM Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> wrote: > > The NEC NL8048HL11 is a 10.4cm WVGA (800x480) panel with a 24-bit RGB > parallel data interface and an SPI control interface. > > Signed-off-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> > --- > Changes since v1: > > - Convert to YAML > --- > .../display/panel/nec,nl8048hl11.yaml | 49 +++++++++++++++++++ > 1 file changed, 49 insertions(+) > create mode 100644 Documentation/devicetree/bindings/display/panel/nec,nl8048hl11.yaml > > diff --git a/Documentation/devicetree/bindings/display/panel/nec,nl8048hl11.yaml b/Documentation/devicetree/bindings/display/panel/nec,nl8048hl11.yaml > new file mode 100644 > index 000000000000..cc3d40975828 > --- /dev/null > +++ b/Documentation/devicetree/bindings/display/panel/nec,nl8048hl11.yaml > @@ -0,0 +1,49 @@ > +# SPDX-License-Identifier: GPL-2.0 > +%YAML 1.2 > +--- > +$id: http://devicetree.org/schemas/display/panel/nec,nl8048hl11.yaml# > +$schema: http://devicetree.org/meta-schemas/core.yaml# > + > +title: NEC NL8048HL11 4.1" WVGA TFT LCD panel > + > +description: > + The NEC NL8048HL11 is a 4.1" WVGA TFT LCD panel with a 24-bit RGB parallel > + data interface and an SPI control interface. > + > +maintainers: > + - Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> > + > +allOf: > + - $ref: panel-common.yaml# > + > +properties: > + compatible: > + const: nec,nl8048hl11 > + > + label: true > + reset-gpios: true > + port: true > + > +required: > + - compatible > + - reset-gpios > + - port > + > +additionalProperties: false > + > +examples: Your example will fail on 'make dt_binding_check'... > + - | > + lcd_panel: panel { SPI devices have to have a minimal SPI controller parent. Primarily just #size-cells and #address-cells are needed. 'reg' is missing here too. > + compatible = "nec,nl8048hl11"; > + spi-max-frequency = <10000000>; This needs to be listed in properties ideally with some constraints. > + > + reset-gpios = <&gpio7 7 GPIO_ACTIVE_LOW>; And GPIO_ACTIVE_LOW. You have to add includes you need. > + > + port { > + lcd_in: endpoint { > + remote-endpoint = <&dpi_out>; > + }; > + }; > + }; > + > +... > -- > Regards, > > Laurent Pinchart > _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
