On Mon, Nov 5, 2018 at 4:09 PM Maxime Ripard <maxime.ripard@xxxxxxxxxxx> wrote: > > On Sat, Nov 03, 2018 at 03:38:52PM +0530, Jagan Teki wrote: > > Instruction loop selection would require before writing > > loop number registers, so enable idle, LP11 bits on > > loop selection register. > > > > Reference code available in BSP > > (in drivers/video/sunxi/disp2/disp/de/lowlevel_sun50iw1/de_dsi.c) > > (dsi_dev[sel]->dsi_inst_loop_sel.dwval = 2<<(4*DSI_INST_ID_LP11) | > > 3<<(4*DSI_INST_ID_DLY); > > > > Signed-off-by: Jagan Teki <jagan@xxxxxxxxxxxxxxxxxxxx> > > --- > > drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c | 4 ++++ > > 1 file changed, 4 insertions(+) > > > > diff --git a/drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c b/drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c > > index da152c21ec62..077b57ec964c 100644 > > --- a/drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c > > +++ b/drivers/gpu/drm/sun4i/sun6i_mipi_dsi.c > > @@ -397,6 +397,10 @@ static void sun6i_dsi_setup_inst_loop(struct sun6i_dsi *dsi, > > struct mipi_dsi_device *device = dsi->device; > > u16 delay; > > > > + regmap_write(dsi->regs, SUN6I_DSI_INST_LOOP_SEL_REG, > > + DSI_INST_ID_HSC << (4 * DSI_INST_ID_LP11) | > > + DSI_INST_ID_HSD << (4 * DSI_INST_ID_DLY)); > > + > > Please put this with the other instructions settings below. Does that mean after computation delay code? _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
