Hi Hean Loong, On Monday, 4 September 2017 09:09:11 EEST Ong, Hean Loong wrote: > On Mon, 2017-08-28 at 13:06 +0800, Ong, Hean Loong wrote: > > On Thu, 2017-08-24 at 12:39 +0300, Laurent Pinchart wrote: > >> On Thursday, 24 August 2017 08:41:50 EEST Ong, Hean Loong wrote: > >>> > >>> Hi Laurent, > >>> > >>> I removed the examples for the HDMI in the draft below. The > >>> connections between the VIP and Display Port IP or any display > >>> connector are determined by HW logic. There are currently no SW > >>> defined encoders or connectors that is connected to the AVALON-ST > >>> other than the Intel VIP Frame Buffer II. Therefore there are no > >>> examples for the Display Port encoder and connector. > >> > >> But there must be an encoder, even if its default configuration > >> makes it usable without a softwarer driver at the moment. As the > >> encoder is there in hardware, it should be described in DT. > > > > I attach some links regarding the simple example designs for the > > Display Port IP > > > > The link below has a example design of how the VIP is built along > > with the Display Port IP into the FPGA connected to the DDR RAM accessed > > by ARM or any controller. Please look at the Introduction section of the > > link below > > http://www.alterawiki.com/wiki/DisplayPort_Design_Example_14.0_(RX_an > > d_TX)#DisplayPort_IP_Core > > > > The proposed design in the link above and the design we are > > implementing are almost the same (FPGA part) > > That the Intel(Altera) FPGA VIP is the sole interface for the ARM > > controller to connect to via memory mapping on the DDR > > > > Please go to Source Functional Description section in the PDF below. > > It has information on how the encoder is built for the FPGA design of the > > Display Port > > https://www.altera.com/ja_JP/pdfs/literature/ug/ug_displayport.pdf > > > > More information on the Display Port IP encoder could be found in the > > link below. The Tx Transceiver interface has some information on how the > > source clocks works in the FPGA tranceiver > > https://www.altera.com/documentation/hco1410462777019.html#hco1410462 > > 323311 > > Would the information provided in the above links suffice to explain > the relationship between DDR, VIP and Display Port IP ? It does, thank you, and sorry for the late reply. The documents you've provided show that the Display Port transmitter is an IP core in the FPGA, connected to the VIP output, and configurable from the ARM side through memory-mapped registers. It should thus be modelled in DT with a separate DT node, and connections should be modelled using the OF graph DT bindings, like you've done in the latest version of your patch series. The Display Port transmitter should also have DT bindings, and a Linux kernel driver, but that can be submitted in a separate patch series. -- Regards, Laurent Pinchart _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
