Hello Philipp, > Looking at the hardware user's guide [1] chapter 9 (VGA and DVI out), I > notice that the TFP410PA bridge seems to be connected to the DISP2_DAT > data lines, but uses the DISP1_H/V sync signals (which I can't believe > is right), according to figure 9-1. But the device tree pin > configuration configures the DISP1_DAT data lines with pinctrl_ipu_disp1 > instead. This pin configuration was moved there from imx51.dtsi, so I > think it was just never adapted for this boards' quirks. Interesting, thanks a lot for pointing that out. The figure 1-3 on page 6 shows both Disp-1 and Disp-2 going to the DVI-I connector, however the output of Disp-2 goes through the DAC so I suppose that's for the VGA pins. The figure 9-1 seems to be in conflict with that. DISP1_DAT isn't used at all there, but DISP2_DAT (albeit different pin ranges) go to both the ADV7123 and TFP410PA. > It might also be useful to find out which GPIOs are connected to the > TFP410 power down and reset lines. Yes, indeed. Luckily it works in u-boot so that's a reference. Regards, Wladimir _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
