Hi Javier,
2016년 05월 31일 07:58에 Javier Martinez Canillas 이(가) 쓴 글:
> Hello Inki,
>
> On 04/05/2016 04:27 AM, Inki Dae wrote:
>> This patch adds HW trigger support on i80 mode.
>>
>> Until now, Exynos DRM only supported SW trigger which was set
>> SWTRGCMD bit of TRIGCON register by CPU to transfer scanout
>> buffer to Display bus device or panel.
>>
>> With this patch, the transmission to Display bus device or
>> panel will be initiated by FIMD controller.
>>
>> Signed-off-by: Inki Dae <inki.dae@xxxxxxxxxxx>
>> ---
>
> There is a regression for the Exynos5800 Peach Pi Chromebook display due
> this patch. The display is blank and I noticed that it only happens when
> HW start trigger is enabled, but works with SW trigger (as it was before).
Posted below pathch,
[PATCH] drm/exynos: fimd: fix trigger mode change regression
Can you test it again with the patch? I have no HW to test it. :(
Thanks,
Inki Dae
>
> So for example with the following diff on top of v4.7-rc1, display works
> again. Do you have any hints about what could be the issue?
>
> diff --git a/drivers/gpu/drm/exynos/exynos_drm_fimd.c b/drivers/gpu/drm/exynos/exynos_drm_fimd.c
> index 0444d7fc400d..8c62830e9514 100644
> --- a/drivers/gpu/drm/exynos/exynos_drm_fimd.c
> +++ b/drivers/gpu/drm/exynos/exynos_drm_fimd.c
> @@ -171,7 +171,7 @@ static struct fimd_driver_data exynos5420_fimd_driver_data = {
> .lcdblk_vt_shift = 24,
> .lcdblk_bypass_shift = 15,
> .lcdblk_mic_bypass_shift = 11,
> - .trg_type = I80_HW_TRG,
> .has_shadowcon = 1,
> .has_vidoutcon = 1,
> .has_vtsel = 1,
>
> Best regards,
>
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
