On Mon, Nov 29, 2010 at 06:48:25PM -0500, Ric Wheeler wrote: > On 11/29/2010 05:05 PM, Darrick J. Wong wrote: >> On certain types of hardware, issuing a write cache flush takes a considerable >> amount of time. Typically, these are simple storage systems with write cache <snip> >> lowered performance considerably, especially in the case where directio was in >> use. Therefore, this patch adds the coordination code directly to ext4. > > Hi Darrick, > > Just curious why we would need to have batching in both places? Doesn't > your patch set make the jbd2 transaction batching redundant? The code path that I'm changing is only executed when ext4_sync_file determines that the flush can't go through the journal, i.e. whenever the previous sequence of data writes hasn't resulted in any metadata updates, or if the transaction that went with the previous writes has already been committed. > I noticed that the patches have a default delay and a mount option to > override that default. The jbd2 code today tries to measure the average > time needed in a transaction and automatically tune itself. Can't we do > something similar with your patch set? (I hate to see yet another mount > option added!) The mount option is no longer the delay time, as it was in previous patches. In the (unreleased) v5 patch, the code automatically tuned the delay based on the average flush time. However, we then observed very low flush times (< 2ms) and about a 6% regression on our arrays with battery-backed write cache, so the auto-tune code was then adapted in v6 to skip the coordination if the average flush time falls below that threshold, as it does on our arrays. Therefore, the new mount option exists to override the default threshold. --D -- dm-devel mailing list dm-devel@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/dm-devel
