On 2/3/2010 11:55 AM, Scott Dungan wrote:
Yes, I understand that. If I run 'multipathd -k' and then help, these
are the commands that are listed:
list|show paths
list|show maps
add path $path
remove|del path $path
add map $map
remove|del map $map
switch|switchgroup map $map group $group
dump pathvec
reconfigure
disablequeueing map $map
restorequeueing map $map
Where are the 'reinstate path' or 'fail path' directives you mention
in this thread? In case this is a version issue, we are running with
version device-mapper-multipath-0.4.7-30.el5_4.4. What version are you
running where the 'reinstate path' or 'fail path' directives are
listed in help or otherwise function?
-Scott
--
dm-devel mailing list
dm-devel@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/dm-devel
It looks like I have answered my own question. I was confused about
which version we were running. I was testing against version 4.5. Those
commands are not available in version 4.5 (RHEL 4.8). They are present
in version 4.7 (RHEL 5.x).
Thanks for your help.
-Scott
--
Scott A Dungan
Systems Administrator
GPS Division
California Institute of Technology
Phone: (626) 395-3170
Fax: (626) 585-1917
--
dm-devel mailing list
dm-devel@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/dm-devel
