Food for comment, no specific issues or questions.
Some of the SATA controllers on the market are in a grey area between
"completely non-RAID" and "completely hardware RAID". These
"in-between" SATA controllers provide some features which can be used to
accelerate RAID in certain cases, and it would be nice to be able to
make use of these features. In one case, -not- making use of these
"RAID offload" features causes a distinct performance loss.
Here's a rough description of the features provided.
1) Transaction sequencing. Consider that N disk transactions comprise a
single RAID1 write. The hardware can be set up to wait until all N
transactions are complete, before sending an interrupt. This is
applicable to Marvell and Promise SATA, among others.
Block layer comments: Not really compatible with the way the Linux
block layer works, but who knows, maybe some genius has ideas.
2) Copy elimination. All disk transactions on the Promise SX4 go
through an on-board DIMM (128M - 2G), before being sent to the attached
controllers. I would love to use this to eliminate data duplication on
RAID1 and RAID5 writes.
3) RAID5 XOR offload. Some Promise (and other) controllers support
this. Since modern CPUs are so fast, generally this isn't a useful
feature by itself. However, when combined with #2, you can offload
quite a bit of RAID5 onto the hardware.
4) Off-board RAID balancing. With disk transactions funnelled through
the bottleneck of an on-board DIMM, the hardware is actually in a better
position to decide how to balance raid 1/5 reads. Only one case of that
in hardware I know of, though.
There was a fifth feature, but I forget what it was. :)
As some of you have no doubt already noted, these features are specific
to a single controller, while a device-mapper or md RAID need not be.
To facilitate this, I forsee needing to create a "hardware group" or
"block device group", to which would allow the necessary associations to
be utilized where available, while being 100% software in all other cases.
Or maybe, allow the user to set a flag that tells md to pass a request
directly through to the low-level driver, in certain situations ("pass
through all RAID1 writes, but handle everything else in software"). /me
thinks out loud...
In general, storage hardware seems to be trending towards "put the fast
path in hardware, let software handle the rest", which is OK with me...
Jeff