On 10/21/2015 04:12 PM, Markus Reichl wrote:
Am 21.10.2015 um 12:16 schrieb Javier Martinez Canillas:
Hello Alim,
On 10/21/2015 08:09 AM, Alim Akhtar wrote:
[snip]
Hi Alim,
I have installed your patch set above with git am on top of
4.3.0-rc6-00108-gce1fad2 torvalds/linux of today
with make exynos_defconfig on Odroid U3.
which exynos soc Odroid U3 uses?
OK, I can see its uses exynos4412 and exynos4412-odroidu3.dts does
include exynos4.dtsi,
so these should have worked.
"halt -p" worked (power 0.0W).
"reboot" got stuck at 0.5W.
reboot stuck mean system does not reboot any more?
It freezes when going for reboot.
Have to power off/on to boot again.
Btw I use an mmc, not an sd-card.
No other HW connected, just LAN-cable.
Bootloader is u-boot v2015.10.
o
Have checked on 4.3.0-rc6-00006-gd03c139e7e77, still works on peach boards.
Sorry I don't have Odroid U3 with me, may be Javier or Krzysztof might help here to check whats wrong. To me its looks more of a board specific issue for now.
Krzysztof has an Odroid XU3 lite and I have an Odroid XU4, both uses an
Exynos5422 so we can't check what's wrong with Odroid U3 (Exynos4412).
Having said that I think I know what is the issue here. Markus said that
he is using an eMMC instead of an uSD (which is what I used and my guess
is that Krzysztof did too).
Now, there is a subtle difference between the old PMU restart handler
and the syscon-reboot one, and that is the restart handler priorities:
notifier priority
------------------------------------
pmu_restart_notify 128
mmc_pwrseq_emmc_reset_nb 129
syscon_restart_handle 192
So, without Alim's patches, first the eMMC reset handler will be called
and then the PMU restart handler but after his series, the syscon reset
handler has a higher priority so the eMMC reset will never be called.
But the problem is that the eMMC card has to be properly reset on system
restart to allow the SoC iROM to be able to read the bootloader from the
eMMC since the iROM doesn't have restart logic and the card shouldn't be
left in an unknown state.
So the problem here is not that the system is not being reset (that I
think that works) but that on reboot, the system is not able to boot
again since the ROM is not able to read the second stage bootloader.
Markus,
Can you please test following patch [0] on top of Alim's series? If that
works then it should either be part of Alim's series or the patches will
have to wait until that patch lands into mainline. I don't have an eMMC
to test it in XU4 but I'm pretty confident that it will solve the issue.
Hi Javier,
your patch fixes the issue, reboot works now on U3.
Good to know that.
Thanks
Tested-by: Markus Reichl <m.reichl@xxxxxxxxxxxxx>
Thanks,
--
Markus
Best regards,
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
