The power configuration on this board is the same as the pcDuino v3. This will enable frequency/voltage scaling over the standard A20 operating points from 144 MHz to 960 MHz. Tested using cpufreq-ljt-stress-test on two pcDuino v3 Nano boards; also tested successfully with voltages reduced by 0.025 V. Signed-off-by: Adam Sampson <ats@xxxxxxxxx> --- arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts | 35 ++++++++++++++++++++++++--- 1 file changed, 31 insertions(+), 4 deletions(-) diff --git a/arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts b/arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts index ee85e07..1757a6a 100644 --- a/arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts +++ b/arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts @@ -82,6 +82,10 @@ status = "okay"; }; +&cpu0 { + cpu-supply = <®_dcdc2>; +}; + &ehci0 { status = "okay"; }; @@ -108,13 +112,9 @@ status = "okay"; axp209: pmic@34 { - compatible = "x-powers,axp209"; reg = <0x34>; interrupt-parent = <&nmi_intc>; interrupts = <0 IRQ_TYPE_LEVEL_LOW>; - - interrupt-controller; - #interrupt-cells = <1>; }; }; @@ -182,6 +182,33 @@ status = "okay"; }; +#include "axp209.dtsi" + +®_dcdc2 { + regulator-always-on; + regulator-min-microvolt = <1000000>; + regulator-max-microvolt = <1400000>; + regulator-name = "vdd-cpu"; +}; + +®_dcdc3 { + regulator-always-on; + regulator-min-microvolt = <1000000>; + regulator-max-microvolt = <1400000>; + regulator-name = "vdd-int-pll"; +}; + +®_ldo1 { + regulator-name = "vdd-rtc"; +}; + +®_ldo2 { + regulator-always-on; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3000000>; + regulator-name = "avcc"; +}; + /* A single regulator (U24) powers both USB host ports. */ ®_usb1_vbus { pinctrl-0 = <&usb1_vbus_pin_pcduino3_nano>; -- 2.1.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html