Add the sub-mailbox nodes that are used to communicate between MPU and the remote processors IPU1, IPU2 and DSP1. These match the respective node definitions on DRA74x to maintain compatibility for the equivalent remote processors. There is no DSP2 on DRA72x, and so the corresponding sub-mailbox node is not added. These sub-mailbox nodes are added to match the hard-coded mailbox configuration used within the TI IPC 3.x software package. The Dual-Cortex M4 IPU1 and IPU2 processor sub-systems are assumed to be running in SMP-mode, and hence only a single sub-mailbox node is added for each. All these sub-mailbox nodes are left in disabled state, and should be enabled (and modified if needed) as per the individual product configuration in the corresponding board dts files. Signed-off-by: Suman Anna <s-anna@xxxxxx> --- arch/arm/boot/dts/dra72x.dtsi | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+) diff --git a/arch/arm/boot/dts/dra72x.dtsi b/arch/arm/boot/dts/dra72x.dtsi index eaca143faa77..70a217050a4c 100644 --- a/arch/arm/boot/dts/dra72x.dtsi +++ b/arch/arm/boot/dts/dra72x.dtsi @@ -45,3 +45,24 @@ <&dss_video1_clk>; clock-names = "fck", "video1_clk"; }; + +&mailbox5 { + mbox_ipu1_ipc3x: mbox_ipu1_ipc3x { + ti,mbox-tx = <6 2 2>; + ti,mbox-rx = <4 2 2>; + status = "disabled"; + }; + mbox_dsp1_ipc3x: mbox_dsp1_ipc3x { + ti,mbox-tx = <5 2 2>; + ti,mbox-rx = <1 2 2>; + status = "disabled"; + }; +}; + +&mailbox6 { + mbox_ipu2_ipc3x: mbox_ipu2_ipc3x { + ti,mbox-tx = <6 2 2>; + ti,mbox-rx = <4 2 2>; + status = "disabled"; + }; +}; -- 2.5.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html