Hi Gary, Am Montag, den 07.09.2015, 18:57 +0200 schrieb Gary Bisson: > This patch adds the different touchscreens that can be connected using > the displays available for this board. > http://boundarydevices.com/product-category/displays/ > > Signed-off-by: Gary Bisson <gary.bisson@xxxxxxxxxxxxxxxxxxx> > --- > arch/arm/boot/dts/imx6qdl-nitrogen6x.dtsi | 16 ++++++++++++++++ > 1 file changed, 16 insertions(+) > > diff --git a/arch/arm/boot/dts/imx6qdl-nitrogen6x.dtsi b/arch/arm/boot/dts/imx6qdl-nitrogen6x.dtsi > index ad16dce..ec9da5e 100644 > --- a/arch/arm/boot/dts/imx6qdl-nitrogen6x.dtsi > +++ b/arch/arm/boot/dts/imx6qdl-nitrogen6x.dtsi > @@ -284,6 +284,22 @@ > pinctrl-names = "default"; > pinctrl-0 = <&pinctrl_i2c3>; > status = "okay"; > + > + egalax_ts@04 { > + compatible = "eeti,egalax_ts"; > + reg = <0x04>; > + interrupt-parent = <&gpio1>; > + interrupts = <9 2>; Please use IRQ_TYPE_EDGE_FALLING here. > + wakeup-gpios = <&gpio1 9 0>; And that would be GPIO_ACTIVE_HIGH. Should this be changed to GPIO_ACTIVE_LOW instead? From other device tree files and from what the driver does, it looks as if a wakeup is issued by forcing a falling edge on the IRQ pin. > + }; > + > + ft5x06_ts@38 { > + compatible = "edt,edt-ft5x06"; > + reg = <0x38>; > + interrupt-parent = <&gpio1>; > + interrupts = <9 2>; IRQ_TYPE_EDGE_FALLING > + wakeup-gpios = <&gpio1 9 0>; GPIO_ACTIVE_HIGH > + }; > }; best regards Philipp -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html