Hi,
On 08/21/2015 02:20 AM, Marek Vasut wrote:
> From: Graham Moore <grmoore@xxxxxxxxxxxxxxxxxxxxx>
>
> Add binding document for the Cadence QSPI controller.
>
> Signed-off-by: Graham Moore <grmoore@xxxxxxxxxxxxxxxxxxxxx>
> Signed-off-by: Marek Vasut <marex@xxxxxxx>
> Cc: Alan Tull <atull@xxxxxxxxxxxxxxxxxxxxx>
> Cc: Brian Norris <computersforpeace@xxxxxxxxx>
> Cc: David Woodhouse <dwmw2@xxxxxxxxxxxxx>
> Cc: Dinh Nguyen <dinguyen@xxxxxxxxxxxxxxxxxxxxx>
> Cc: Graham Moore <grmoore@xxxxxxxxxxxxxxxxxxxxx>
> Cc: Vikas MANOCHA <vikas.manocha@xxxxxx>
> Cc: Yves Vandervennet <yvanderv@xxxxxxxxxxxxxxxxxxxxx>
> Cc: devicetree@xxxxxxxxxxxxxxx
> ---
> .../devicetree/bindings/mtd/cadence-quadspi.txt | 56 ++++++++++++++++++++++
> 1 file changed, 56 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/mtd/cadence-quadspi.txt
>
> V2: Add cdns prefix to driver-specific bindings.
> V3: Use existing property "is-decoded-cs" instead of creating a
> duplicate, "ext-decoder". Timing parameters are in nanoseconds,
> not master reference clocks. Remove bus-num completely.
> V4: Add new properties fifo-width and trigger-address
> V7: - Prefix all of the Cadence-specific properties with cdns prefix,
> those are in particular "cdns,is-decoded-cs", "cdns,fifo-depth",
> "cdns,fifo-width", "cdns,trigger-address".
> - Drop bogus properties which were not used and were incorrect.
> V8: Align lines to 80 chars.
>
> diff --git a/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt b/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt
> new file mode 100644
> index 0000000..f248056
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt
> @@ -0,0 +1,56 @@
> +* Cadence Quad SPI controller
> +
> +Required properties:
> +- compatible : Should be "cdns,qspi-nor".
> +- reg : Contains two entries, each of which is a tuple consisting of a
> + physical address and length. The first entry is the address and
> + length of the controller register set. The second entry is the
> + address and length of the QSPI Controller data area.
still hooked up with "Controller data area", it is ambiguous.
Use something which is more clear: Nor Flash memory mapped address.
> +- interrupts : Unit interrupt specifier for the controller interrupt.
> +- clocks : phandle to the Quad SPI clock.
> +- cdns,fifo-depth : Size of the data FIFO in words.
> +- cdns,fifo-width : Bus width of the data FIFO in bytes.
> +- cdns,trigger-address : 32-bit indirect AHB trigger address.
> +
> +Optional properties:
again, is it optional ? can the driver be used without these properties ?
> +- cdns,is-decoded-cs : Flag to indicate whether decoder is used or not.
again, add info what the decoder is for ?
> +
> +Optional subnodes:
> +Subnodes of the Cadence Quad SPI controller are spi slave nodes with additional
> +custom properties:
> +- cdns,read-delay : Delay for read capture logic, in clock cycles
> +- cdns,tshsl-ns : Delay in nanoseconds for the length that the master
> + mode chip select outputs are de-asserted between
> + transactions.
> +- cdns,tsd2d-ns : Delay in nanoseconds between one chip select being
> + de-activated and the activation of another.
> +- cdns,tchsh-ns : Delay in nanoseconds between last bit of current
> + transaction and deasserting the device chip select
> + (qspi_n_ss_out).
> +- cdns,tslch-ns : Delay in nanoseconds between setting qspi_n_ss_out low
> + and first bit transfer.
> +
> +Example:
> +
> + qspi: spi@ff705000 {
> + compatible = "cdns,qspi-nor";
> + #address-cells = <1>;
> + #size-cells = <0>;
> + reg = <0xff705000 0x1000>,
> + <0xffa00000 0x1000>;
> + interrupts = <0 151 4>;
> + clocks = <&qspi_clk>;
> + cdns,is-decoded-cs;
flag value ?
Cheers,
Vikas
> + cdns,fifo-depth = <128>;
> + cdns,fifo-width = <4>;
> + cdns,trigger-address = <0x00000000>;
> +
> + flash0: n25q00@0 {
> + ...
> + cdns,read-delay = <4>;
> + cdns,tshsl-ns = <50>;
> + cdns,tsd2d-ns = <50>;
> + cdns,tchsh-ns = <4>;
> + cdns,tslch-ns = <4>;
> + };
> + };
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
