Re: [linux-sunxi] [RFC] ARM: dts: sunxi: Add regulators and board-specific operating points for LeMaker BananaPi

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Hi,

Chen-Yu Tsai schrieb am 27.07.2015 15:14:
>> ChenYu (in the CC), since you did most of the original work here, do
>> you know why we have an op at 0.9 volt, but none of our boards allow the
>> voltage to go that low in the regulator settings ?
> 
> I'm on vacation now, so apologies for the bad formatting.
> 
> The OPPs are from a common subset
> of the settings from the fex files available
> at the time. Some fex files actually set
> min and max voltage thus eliminating
> the highest and lowest OPPs.
> 
> At least that is how Maxime and I
> interpreted them.

IMHO for a common maximum opp that's a good approach. But for the lowest
frequency setting, it would seem more logical to me, to raise the voltage
to a point where all boards will run fine with them, unless those boards 
cannot handle the frequency regardless of the higher voltage.

Regards,

Timo
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux