On Saturday 11 July 2015 12:41 PM, Krzysztof Kozlowski wrote:
W dniu 09.07.2015 o 20:47, Vaibhav Hiremath pisze:
88PM800 family of device supports output of 32KHz clock (low jitter)
on CLK32K2/3 pin which can be supplied to other peripherals on the board.
This patch adds the devicetree binding to enable this feature.
Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath@xxxxxxxxxx>
---
Documentation/devicetree/bindings/mfd/88pm800.txt | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/Documentation/devicetree/bindings/mfd/88pm800.txt b/Documentation/devicetree/bindings/mfd/88pm800.txt
index dec842f..ae1311c 100644
--- a/Documentation/devicetree/bindings/mfd/88pm800.txt
+++ b/Documentation/devicetree/bindings/mfd/88pm800.txt
@@ -9,6 +9,12 @@ Required parent device properties:
- #interrupt-cells : should be 1.
The cell is the 88pm80x local IRQ number
+Optional properties :
+ - marvell,88pm800-32khz-xolj-out-en : If set, driver will enable low jitter
+ version of 32Khz clock output on
I am not sure if I understand it correctly. The hardware always has such
clocks and you only want to enable/disable it in DT? Any reasons why
these should not be enabled always?
Small amount of Power savings...
Although currently I do not have power numbers to justify this.
As per spec, (it only talks about power consumption in power down state)
Power-down State => VSYS > 2.8 => 4.5 μA
CLK32K2 = 0 => 18 μW
Enabling it in DT does not look like a job for DT. Maybe you there
should be just a clock driver (clock provider)?
It's init time (and one time) settings, wouldn't clock-provider
be overkill for this?
Thanks,
Vaibhav
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
