On Mon, 2015-05-11 at 03:38 +0000, Kuninori Morimoto wrote:
> Hi Ben
>
> Thank you for your patch
>
> > Based on work by Shinobu Uehara and Ben Dooks. This adds the
> > voltage switch operation needed for all UHS-I modes, but not
> > the tuning needed for SDR-104 which will come later.
> >
> > XXX The card_busy implementation is a bit of a guess.
> >
> > Signed-off-by: Ben Hutchings <ben.hutchings@xxxxxxxxxxxxxxx>
>
> If original patch was created by Shinobu/Ben Dooks,
> and you updated it, I prefer to add these guys on Signed-off-by line.
>
> > static const struct mmc_host_ops tmio_mmc_ops = {
> > .request = tmio_mmc_request,
> > .set_ios = tmio_mmc_set_ios,
> > .get_ro = tmio_mmc_get_ro,
> > .get_cd = mmc_gpio_get_cd,
> > .enable_sdio_irq = tmio_mmc_enable_sdio_irq,
> > + .start_signal_voltage_switch
> > + = tmio_mmc_start_signal_voltage_switch,
> > + .card_busy = tmio_mmc_card_busy,
> > .multi_io_quirk = tmio_multi_io_quirk,
> > };
>
> I prefer to separate this patch for these 2 new callbacks if possible.
They are both used only by mmc_set_signal_voltage(), which warns if only
start_signal_voltage_switch is implemented. So it doesn't make sense to
add them separately.
Ben.
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
