From: Dimitri Fedrau <dimitri.fedrau@xxxxxxxxxxxx>
Add property tx-amplitude-100base-tx-percent in the device tree bindings
for configuring the tx amplitude of 100BASE-TX PHYs. Modifying it can be
necessary to compensate losses on the PCB and connector, so the voltages
measured on the RJ45 pins are conforming.
Signed-off-by: Dimitri Fedrau <dimitri.fedrau@xxxxxxxxxxxx>
---
Documentation/devicetree/bindings/net/ethernet-phy.yaml | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
index 2c71454ae8e362e7032e44712949e12da6826070..e0c001f1690c1eb9b0386438f2d5558fd8c94eca 100644
--- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
@@ -232,6 +232,12 @@ properties:
PHY's that have configurable TX internal delays. If this property is
present then the PHY applies the TX delay.
+ tx-amplitude-100base-tx-percent:
+ description:
+ Transmit amplitude gain applied for 100BASE-TX. When omitted, the PHYs
+ default will be left as is.
+ default: 100
+
leds:
type: object
--
2.39.5
