On Wed, Dec 04, 2024 at 02:19:56PM +0530, Krishna Chaitanya Chundru wrote:
[...]
> > > > + pcie@3,0 {
> > > > + reg = <0x21800 0x0 0x0 0x0 0x0>;
> > > > + #address-cells = <3>;
> > > > + #size-cells = <2>;
> > > > + device_type = "pci";
> > > > + ranges;
> > > > + bus-range = <0x05 0xff>;
> > > > +
> > > > + qcom,tx-amplitude-millivolt = <10>;
> > > > + pcie@0,0 {
> > > > + reg = <0x50000 0x0 0x0 0x0 0x0>;
> > > > + #address-cells = <3>;
> > > > + #size-cells = <2>;
> > > > + device_type = "pci";
> > >
> > > There's a 2nd PCI-PCI bridge?
> > This the embedded ethernet port which is as part of DSP3.
> >
> Hi Rob,
>
> Can you please check my response on your queries, if you need
> any extra information, we can provide to sort this out.
>
I believe Rob was pointing the 'device_type' property which is not needed for
PCI device nodes but only for nodes implementing PCI bus (like host bridge, PCI
bridge).
- Mani
--
மணிவண்ணன் சதாசிவம்
