Configure the EEPROMs which are found on the different camera sensors on
this device.
The pull-up regulator for these I2C busses is vreg_cam_vio_1p8, the same
supply that powers VCC of all the EEPROMs.
Signed-off-by: Danila Tikhonov <danila@xxxxxxxxxxx>
---
.../boot/dts/qcom/sm7325-nothing-spacewar.dts | 32 +++++++++++++++++--
1 file changed, 29 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sm7325-nothing-spacewar.dts b/arch/arm64/boot/dts/qcom/sm7325-nothing-spacewar.dts
index 4f964e5d34da..0c89f7726865 100644
--- a/arch/arm64/boot/dts/qcom/sm7325-nothing-spacewar.dts
+++ b/arch/arm64/boot/dts/qcom/sm7325-nothing-spacewar.dts
@@ -843,7 +843,15 @@ &cci0 {
};
&cci0_i2c0 {
- /* sony,imx471 (Front) */
+ /* D-PHY sony,imx471 (Front) @ 0x1a */
+
+ camf_p24c64f: eeprom@52 {
+ compatible = "puya,p24c64f",
+ "atmel,24c64";
+ reg = <0x52>;
+ vcc-supply = <&vreg_cam_vio_1p8>;
+ read-only;
+ };
};
&cci1 {
@@ -851,11 +859,29 @@ &cci1 {
};
&cci1_i2c0 {
- /* samsung,s5kjn1 (Rear-aux UW) */
+ /* actuator (For Ultra Wide sensor) @ 0xc */
+ /* D-PHY samsung,s5kjn1 (Ultra Wide) @ 0x2d */
+
+ camu_gt24p128e: eeprom@51 {
+ compatible = "giantec,gt24p128e",
+ "atmel,24c128";
+ reg = <0x51>;
+ vcc-supply = <&vreg_cam_vio_1p8>;
+ read-only;
+ };
};
&cci1_i2c1 {
- /* sony,imx766 (Rear Wide) */
+ /* actuator (For Wide sensor) @ 0xc */
+ /* C-PHY sony,imx766 (Wide) @ 0x10 */
+
+ camw_gt24p128e: eeprom@50 {
+ compatible = "giantec,gt24p128e",
+ "atmel,24c128";
+ reg = <0x50>;
+ vcc-supply = <&vreg_cam_vio_1p8>;
+ read-only;
+ };
};
&gcc {
--
2.48.1
