On Tuesday 21 April 2015 02:49 AM, Mark Brown wrote:
* PGP Signed by an unknown key
On Mon, Apr 20, 2015 at 06:24:17PM +0530, Laxman Dewangan wrote:
+Optional properties:
+
+-maxim,externally-enable: boolean, externally control the regulator output
+ enable/disable.
I'd have expected this to be enabled if a GPIO is provided to do the
control rather than having a specific property for it.
Curently there is no support for providing a GPIO for external control
pins. I have follow on patch to support this as my platform control the
EN pin of the device through GPIO.
There is also case that the EN pin is controlled by the control signal
from host power management controller directly and this control signal
is not exported as GPIO.
So we need this option to support on both cases.
There is another device from Maxim, MAX77621, which is compatible on
register with this device but it has converted the EN pin as SHTDN pin.
I have follow on patches to support this device through this driver
instead of duplicating the driver.
MAX8973: Vout is enabled when EN pin OR EN bit on register is 1.
MAX77621: Vout is enabled when EN pin AND EN bit on register is 1. If EN
pin (renamed as SHTDN pin) goes low, it reset the entire register
configuration.
In our platform, we are using MAX77621 and SHTDN pin of MAX77621 is
controlled through GPIO.
On this case, we will use the GPIO as always HIGH and control Vout
enable/disable through the register EN bit write otherwise, we will need
to restore all configuration on each regulator enable.
So on MAX77621 use, we will provide the GPIO for SHTDN pin to make it
enable always and it will not be controlled externally, it will be
controlled through register access.
+-maxim,enable-falling-slew-rate: boolean, enable falling slew rate.
+-maxim,enable-active-discharge: boolean: enable active discharge.
+-maxim,enable-frequency-shift: boolean, enable 9% frequency shift.
+-maxim,enable-bias-control: boolean, enable bias control. By enabling this
+ startup delay can be reduce to 20us from 220us.
It looks like we should be implementing the set_ramp_delay() operation
here?
It is actually enable_time which changes with this bias enable/disable.
So we need to provide desc->enable_time based on this flag. Currently it
is missing on driver.
I have few more patches, not sent because did not want to bulk the
review and started with small changes which can be discussed easily.
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
