On Wed, 08 Jan 2025 10:36:28 -0600, Ninad Palsule wrote: > Hello, > > Please review the patch set. > > V3: > --- > - Fixed dt_binding_check warnings in ipmb-dev.yaml > - Updated title and description in ipmb-dev.yaml file. > - Updated i2c-protocol description in ipmb-dev.yaml file. > > V2: > --- > Fixed CHECK_DTBS errors by > - Using generic node names > - Documenting phy-mode rgmii-rxid in ftgmac100.yaml > - Adding binding documentation for IPMB device interface > > NINAD PALSULE (7): > ARM: dts: aspeed: system1: Add IPMB device > ARM: dts: aspeed: system1: Add GPIO line name > ARM: dts: aspeed: system1: Add RGMII support > ARM: dts: aspeed: system1: Reduce sgpio speed > ARM: dts: aspeed: system1: Update LED gpio name > ARM: dts: aspeed: system1: Remove VRs max8952 > ARM: dts: aspeed: system1: Mark GPIO line high/low > > Ninad Palsule (3): > dt-bindings: net: faraday,ftgmac100: Add phys mode > bindings: ipmi: Add binding for IPMB device intf > ARM: dts: aspeed: system1: Disable gpio pull down > > .../devicetree/bindings/ipmi/ipmb-dev.yaml | 44 +++++ > .../bindings/net/faraday,ftgmac100.yaml | 3 + > .../dts/aspeed/aspeed-bmc-ibm-system1.dts | 177 ++++++++++++------ > 3 files changed, 165 insertions(+), 59 deletions(-) > create mode 100644 Documentation/devicetree/bindings/ipmi/ipmb-dev.yaml > > -- > 2.43.0 > > > My bot found new DTB warnings on the .dts files added or changed in this series. Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings are fixed by another series. Ultimately, it is up to the platform maintainer whether these warnings are acceptable or not. No need to reply unless the platform maintainer has comments. If you already ran DT checks and didn't see these error(s), then make sure dt-schema is up to date: pip3 install dtschema --upgrade New warnings running 'make CHECK_DTBS=y aspeed/aspeed-bmc-ibm-system1.dtb' for 20250108163640.1374680-1-ninad@xxxxxxxxxxxxx: arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-system1.dtb: gpio@1e780000: 'hog-0', 'hog-1', 'hog-2', 'hog-3' do not match any of the regexes: 'pinctrl-[0-9]+' from schema $id: http://devicetree.org/schemas/gpio/aspeed,ast2400-gpio.yaml#
