This series adds dt-bindings and dt's for the NetCube Systems Kumquat
board.
Changes in v2:
Fix the devicetrees according to the
"dt-schema" and "make dtbs_check W=1"
Fix the License of the devicetree as requested
Create a cover letter for the patch series
Changes in v3:
Disable rtc inside the SoC again, as the rtc does not work on the
board
Add the gpio-reserved-ranges property to the pinctrl bindings
Reorder the nodes in the devicetree to match the order of the nodes
in the sun8i-v3s.dtsi file
Changes in v4:
Moved the dtsi change into a sperate patch
Update commit messages to include better descriptions
Add descriptions to the uarts and mmc nodes in the dts file
Add missing newline at the end of the dts file
Removed the gpio-reserved-ranges property from the dts and
from the pinctrl bindings
Remove the rtc status property from the dts file
Changes in v5:
Remove the unused lradc node and it's regualtor, as they
are not used on the board
Add another alias for the SoC's rtc as 'rtc1'
Changes in v6:
Add reason why DS3232+ is preferred over internal rtc
Remove redundant pinctrls from mmc0, mmc1 and i2c0
Reordered eeprom0 and spi0/flash@0 properties
Reordered nodes by their node name alias
Signed-off-by: Lukas Schmid <lukas.schmid@xxxxxxxxxx>
---
Lukas Schmid (4):
dt-bindings: vendor-prefixes: Add NetCube Systems Austria name
dt-bindings: arm: sunxi: Add NetCube Systems Kumquat board
ARM: dts: sunxi: add uart1_pe pinctrl for sun8i-v3s
ARM: dts: sunxi: add support for NetCube Systems Kumquat
.../devicetree/bindings/arm/sunxi.yaml | 5 +
.../devicetree/bindings/vendor-prefixes.yaml | 2 +
arch/arm/boot/dts/allwinner/Makefile | 2 +
.../allwinner/sun8i-v3s-netcube-kumquat.dts | 268 ++++++++++++++++++
arch/arm/boot/dts/allwinner/sun8i-v3s.dtsi | 6 +
5 files changed, 283 insertions(+)
create mode 100644 arch/arm/boot/dts/allwinner/sun8i-v3s-netcube-kumquat.dts
--
2.47.1
