On 12/11/24 16:54, Rob Herring (Arm) wrote:
On Wed, 11 Dec 2024 13:41:19 +0100, Michal Simek wrote:
Hi,
over years there were some changes pushed to U-Boot which were never merged
back to Linux. U-Boot introduced new option OF_UPSTREAM and start to sync
up DTs from Linux back to U-Boot.
This series is addressing differences.
There are still 3 more differences but they should be addressed separately.
Thanks,
Michal
Michal Simek (14):
ARM: zynq: Remove deprecated device_type property
ARM: zynq: DT: List OCM memory for all platforms
ARM: zynq: Mark boot-phase-specific device nodes
ARM: zynq: Do not define address/size-cells for nand-controller
ARM: zynq: Wire smcc with nand/nor memories on zc770 platform
ARM: zynq: Add ethernet phy reset information to DT(zc702)
ARM: zynq: Define u-boot bootscrip addr via DT
ARM: zynq: Point via nvmem0 alias to eeprom on zc702/zc706
ARM: zynq: Define rtc alias on zc702/zc706
ARM: zynq: Rename i2c?-gpio to i2c?-gpio-grp
ARM: zynq: Fix fpga region DT nodes name
ARM: zynq: Enable QSPIs on platforms
ARM: zynq: Add sdhci to alias node
ARM: zynq: Remove ethernet0 alias from Microzed
Sai Krishna Potthuri (1):
ARM: zynq: Replace 'io-standard' with 'power-source' property
arch/arm/boot/dts/xilinx/zynq-7000.dtsi | 33 ++++++-
arch/arm/boot/dts/xilinx/zynq-cc108.dts | 41 ++++++++-
arch/arm/boot/dts/xilinx/zynq-microzed.dts | 10 ++-
arch/arm/boot/dts/xilinx/zynq-parallella.dts | 1 -
arch/arm/boot/dts/xilinx/zynq-zc702.dts | 87 +++++++++++++------
arch/arm/boot/dts/xilinx/zynq-zc706.dts | 67 +++++++++++---
arch/arm/boot/dts/xilinx/zynq-zc770-xm010.dts | 39 ++++++++-
arch/arm/boot/dts/xilinx/zynq-zc770-xm011.dts | 31 +++++++
arch/arm/boot/dts/xilinx/zynq-zc770-xm012.dts | 35 ++++++++
arch/arm/boot/dts/xilinx/zynq-zc770-xm013.dts | 41 ++++++++-
arch/arm/boot/dts/xilinx/zynq-zed.dts | 43 ++++++++-
.../boot/dts/xilinx/zynq-zturn-common.dtsi | 8 ++
arch/arm/boot/dts/xilinx/zynq-zybo-z7.dts | 10 ++-
arch/arm/boot/dts/xilinx/zynq-zybo.dts | 9 +-
14 files changed, 404 insertions(+), 51 deletions(-)
--
2.43.0
My bot found new DTB warnings on the .dts files added or changed in this
series.
Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.
If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:
pip3 install dtschema --upgrade
New warnings running 'make CHECK_DTBS=y xilinx/zynq-cc108.dtb xilinx/zynq-microzed.dtb xilinx/zynq-parallella.dtb xilinx/zynq-zc702.dtb xilinx/zynq-zc706.dtb xilinx/zynq-zc770-xm010.dtb xilinx/zynq-zc770-xm011.dtb xilinx/zynq-zc770-xm012.dtb xilinx/zynq-zc770-xm013.dtb xilinx/zynq-zed.dtb xilinx/zynq-zybo-z7.dtb xilinx/zynq-zybo.dtb' for cover.1733920873.git.michal.simek@xxxxxxx:
arch/arm/boot/dts/xilinx/zynq-parallella.dtb: ethernet@e000b000: ethernet-phy@0: Unevaluated properties are not allowed ('marvell,reg-init' was unexpected)
from schema $id: http://devicetree.org/schemas/net/cdns,macb.yaml#
This is not issue caused by this series.
arch/arm/boot/dts/xilinx/zynq-zc702.dtb: ethernet@e000b000: Unevaluated properties are not allowed ('phy-reset-active-low', 'phy-reset-gpio' were unexpected)
from schema $id: http://devicetree.org/schemas/net/cdns,macb.yaml#
This has been reported by Andrew already and the patch will be removed.
Thanks,
Michal
