During mass manufacturing, we noticed the mmc_rx_crc_error counter,
as reported by "ethtool -S eth0 | grep mmc_rx_crc_error", to increase
above zero during nuttcp speedtests. Most of the time, this did not
affect the achieved speed, but it prompted this investigation.
Cycling through the rx_delay range on six boards (see table below) of
various ages shows that there is a large good region from 0x12 to 0x35
where we see zero crc errors on all tested boards.
The old rx_delay value (0x10) seems to have always been on the edge for
the KSZ9031RNX that is usually placed on Puma.
Choose "rx_delay = 0x23" to put us smack in the middle of the good
region. This works fine as well with the KSZ9131RNX PHY that was used
for a small number of boards during the COVID chip shortages.
Board S/N PHY rx_delay good region
--------- --- --------------------
Puma TT0069903 KSZ9031RNX 0x11 0x35
Puma TT0157733 KSZ9031RNX 0x11 0x35
Puma TT0681551 KSZ9031RNX 0x12 0x37
Puma TT0681156 KSZ9031RNX 0x10 0x38
Puma 17496030079 KSZ9031RNX 0x10 0x37 (Puma v1.2 from 2017)
Puma TT0681720 KSZ9131RNX 0x02 0x39 (alternative PHY used in very few boards)
Intersection of good regions = 0x12 0x35
Middle of good region = 0x23
Relates-to: PUMA-111
Fixes: 2c66fc34e945 ("arm64: dts: rockchip: add RK3399-Q7 (Puma) SoM")
Cc: <stable@xxxxxxxxxxxxxxx>
Reviewed-by: Quentin Schulz <quentin.schulz@xxxxxxxxx>
Signed-off-by: Jakob Unterwurzacher <jakob.unterwurzacher@xxxxxxxxx>
---
v3: use rx_delay = 0x23 instead of 0x11, which was not enough.
v2: cc stable, add "Fixes:", add omitted "there" to commit msg,
add Reviewed-by.
arch/arm64/boot/dts/rockchip/rk3399-puma.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/rockchip/rk3399-puma.dtsi b/arch/arm64/boot/dts/rockchip/rk3399-puma.dtsi
index 9efcdce0f593..f9b4cd2d7daa 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-puma.dtsi
+++ b/arch/arm64/boot/dts/rockchip/rk3399-puma.dtsi
@@ -181,7 +181,7 @@ &gmac {
snps,reset-active-low;
snps,reset-delays-us = <0 10000 50000>;
tx_delay = <0x10>;
- rx_delay = <0x10>;
+ rx_delay = <0x23>;
status = "okay";
};
--
2.39.5
