Add a node for the PMU module of the WCN6855 present on the qcs615 board. Assign its LDO power outputs to the existing WiFi/BT module. This patch depends on below patch series: - base https://lore.kernel.org/all/20241104-add_initial_support_for_qcs615-v5-0-9dde8d7b80b0@xxxxxxxxxxx/ - pmic https://lore.kernel.org/all/20241202-adds-spmi-pmic-peripherals-for-qcs615-v6-0-bdd306b4940d@xxxxxxxxxxx/ - pci https://lore.kernel.org/all/20241122023314.1616353-1-quic_ziyuzhan@xxxxxxxxxxx/ Signed-off-by: Yu Zhang(Yuriy) <quic_yuzha@xxxxxxxxxxx> diff --git a/arch/arm64/boot/dts/qcom/qcs615-ride.dts b/arch/arm64/boot/dts/qcom/qcs615-ride.dts index 66f99cd860b9..80ae02ab2a9b 100644 --- a/arch/arm64/boot/dts/qcom/qcs615-ride.dts +++ b/arch/arm64/boot/dts/qcom/qcs615-ride.dts @@ -14,6 +14,7 @@ / { aliases { serial0 = &uart0; + serial1 = &uart7; }; chosen { @@ -33,6 +34,83 @@ xo_board_clk: xo-board-clk { #clock-cells = <0>; }; }; + + vreg_conn_1p8: vreg_conn_1p8 { + compatible = "regulator-fixed"; + regulator-name = "vreg_conn_1p8"; + startup-delay-us = <4000>; + enable-active-high; + gpio = <&pm8150_gpios 1 GPIO_ACTIVE_HIGH>; + }; + + vreg_conn_pa: vreg_conn_pa { + compatible = "regulator-fixed"; + regulator-name = "vreg_conn_pa"; + startup-delay-us = <4000>; + enable-active-high; + gpio = <&pm8150_gpios 6 GPIO_ACTIVE_HIGH>; + }; + + wcn6855-pmu { + compatible = "qcom,wcn6855-pmu"; + + pinctrl-0 = <&bt_en_state>, <&wlan_en_state>; + pinctrl-names = "default"; + + vddio-supply = <&vreg_conn_pa>; + vddaon-supply = <&vreg_s5a>; + vddpmu-supply = <&vreg_conn_1p8>; + vddrfa0p95-supply = <&vreg_s5a>; + vddrfa1p3-supply = <&vreg_s6a>; + vddrfa1p9-supply = <&vreg_l15a>; + vddpcie1p3-supply = <&vreg_s6a>; + vddpcie1p9-supply = <&vreg_l15a>; + + bt-enable-gpios = <&tlmm 85 GPIO_ACTIVE_HIGH>; + wlan-enable-gpios = <&tlmm 98 GPIO_ACTIVE_HIGH>; + + regulators { + vreg_pmu_rfa_cmn: ldo0 { + regulator-name = "vreg_pmu_rfa_cmn"; + }; + + vreg_pmu_aon_0p59: ldo1 { + regulator-name = "vreg_pmu_aon_0p59"; + }; + + vreg_pmu_wlcx_0p8: ldo2 { + regulator-name = "vreg_pmu_wlcx_0p8"; + }; + + vreg_pmu_wlmx_0p85: ldo3 { + regulator-name = "vreg_pmu_wlmx_0p85"; + }; + + vreg_pmu_btcmx_0p85: ldo4 { + regulator-name = "vreg_pmu_btcmx_0p85"; + }; + + vreg_pmu_rfa_0p8: ldo5 { + regulator-name = "vreg_pmu_rfa_0p8"; + }; + + vreg_pmu_rfa_1p2: ldo6 { + regulator-name = "vreg_pmu_rfa_1p2"; + }; + + vreg_pmu_rfa_1p7: ldo7 { + regulator-name = "vreg_pmu_rfa_1p7"; + }; + + vreg_pmu_pcie_0p9: ldo8 { + regulator-name = "vreg_pmu_pcie_0p9"; + }; + + vreg_pmu_pcie_1p8: ldo9 { + regulator-name = "vreg_pmu_pcie_1p8"; + }; + }; + }; }; &apps_rsc { @@ -231,10 +309,33 @@ &pcie_phy { status = "okay"; }; +&pcieport0 { + wifi@0 { + compatible = "pci17cb,1103"; + reg = <0x10000 0x0 0x0 0x0 0x0>; + + qcom,ath11k-calibration-variant = "QC_QCS615_Ride"; + + vddrfacmn-supply = <&vreg_pmu_rfa_cmn>; + vddaon-supply = <&vreg_pmu_aon_0p59>; + vddwlcx-supply = <&vreg_pmu_wlcx_0p8>; + vddwlmx-supply = <&vreg_pmu_wlmx_0p85>; + vddrfa0p8-supply = <&vreg_pmu_rfa_0p8>; + vddrfa1p2-supply = <&vreg_pmu_rfa_1p2>; + vddrfa1p7-supply = <&vreg_pmu_rfa_1p7>; + vddpcie0p9-supply = <&vreg_pmu_pcie_0p9>; + vddpcie1p8-supply = <&vreg_pmu_pcie_1p8>; + }; +}; + &qupv3_id_0 { status = "okay"; }; +&qupv3_id_1 { + status = "okay"; +}; + &rpmhcc { clocks = <&xo_board_clk>; }; @@ -262,12 +363,42 @@ wake-pins { bias-pull-up; }; }; + + wlan_en_state: wlan-en-state { + pins = "gpio98"; + function = "gpio"; + drive-strength = <16>; + output-high; + bias-pull-up; + }; + + bt_en_state: bt-en-state { + pins = "gpio85"; + function = "gpio"; + output-low; + bias-pull-down; + }; }; &uart0 { status = "okay"; }; +&uart7 { + status = "okay"; + + bluetooth { + compatible = "qcom,wcn6855-bt"; + + vddrfacmn-supply = <&vreg_pmu_rfa_cmn>; + vddaon-supply = <&vreg_pmu_aon_0p59>; + vddbtcmx-supply = <&vreg_pmu_btcmx_0p85>; + vddrfa0p8-supply = <&vreg_pmu_rfa_0p8>; + vddrfa1p2-supply = <&vreg_pmu_rfa_1p2>; + vddrfa1p7-supply = <&vreg_pmu_rfa_1p7>; + }; +}; + &watchdog { clocks = <&sleep_clk>; }; diff --git a/arch/arm64/boot/dts/qcom/qcs615.dtsi b/arch/arm64/boot/dts/qcom/qcs615.dtsi index 808e42f799a6..8465e96e0e8e 100644 --- a/arch/arm64/boot/dts/qcom/qcs615.dtsi +++ b/arch/arm64/boot/dts/qcom/qcs615.dtsi @@ -819,7 +819,7 @@ opp-8000000 { }; }; - pcie@0 { + pcieport0: pcie@0 { device_type = "pci"; reg = <0x0 0x0 0x0 0x0 0x0>; bus-range = <0x01 0xff>; -- 2.34.1
