Enable clock controller, interconnect and pinctrl for Qualcomm QCS615 platform to boot to UART console. The serial engine depends on GCC, interconnect, and pinctrl. It is necessary to build them as built-in modules because the debug console must be registered before userspace is launched. The primary reason for this is that, for example, systemd opens /dev/console at launch (i.e., when the init process starts). Therefore, if we register the console after this, we will not receive console output from systemd. Signed-off-by: Lijuan Gao <quic_lijuang@xxxxxxxxxxx> --- arch/arm64/configs/defconfig | 3 +++ 1 file changed, 3 insertions(+) diff --git a/arch/arm64/configs/defconfig b/arch/arm64/configs/defconfig index 0fad83642034..4657540d0c65 100644 --- a/arch/arm64/configs/defconfig +++ b/arch/arm64/configs/defconfig @@ -607,6 +607,7 @@ CONFIG_PINCTRL_MSM8996=y CONFIG_PINCTRL_MSM8998=y CONFIG_PINCTRL_QCM2290=y CONFIG_PINCTRL_QCS404=y +CONFIG_PINCTRL_QCS615=y CONFIG_PINCTRL_QDF2XXX=y CONFIG_PINCTRL_QDU1000=y CONFIG_PINCTRL_SA8775P=y @@ -1324,6 +1325,7 @@ CONFIG_MSM_MMCC_8998=m CONFIG_QCM_GCC_2290=y CONFIG_QCM_DISPCC_2290=m CONFIG_QCS_GCC_404=y +CONFIG_QCS_GCC_615=y CONFIG_SC_CAMCC_7280=m CONFIG_QDU_GCC_1000=y CONFIG_SC_CAMCC_8280XP=m @@ -1630,6 +1632,7 @@ CONFIG_INTERCONNECT_QCOM_MSM8996=y CONFIG_INTERCONNECT_QCOM_OSM_L3=m CONFIG_INTERCONNECT_QCOM_QCM2290=y CONFIG_INTERCONNECT_QCOM_QCS404=m +CONFIG_INTERCONNECT_QCOM_QCS615=y CONFIG_INTERCONNECT_QCOM_QDU1000=y CONFIG_INTERCONNECT_QCOM_SA8775P=y CONFIG_INTERCONNECT_QCOM_SC7180=y -- 2.46.0
