On Wed, Oct 23, 2024 at 05:03:13PM -0400, Frank Li wrote: > Fix the issue where both 'output-low' and 'output-high' exist under GPIO > hog nodes (rst_usb_hub_hog and sel_usb_hub_hog) when applying device > tree overlays. Since /delete-property/ is not supported in the overlays, > setting 'output-low' results in both properties being present. The > workaround is to disable these hogs and create new ones with 'output-low' > as needed. > > Fix below CHECK_DTBS warning: > arch/arm64/boot/dts/freescale/imx8mn-tqma8mqnl-mba8mx-usbotg.dtb: sel-usb-hub-hog: > {'output-low': True, 'gpio-hog': True, 'gpios': [[1, 0]], 'output-high': True, 'phandle': 108, '$nodename': ['sel-usb-hub-hog']} > is valid under each of {'required': ['output-low']}, {'required': ['output-high'] > > Fixes: 3f6fc30abebc ("arm64: dts: imx8mn: tqma8mqnl-mba8mx: Add USB DR overlay") > Signed-off-by: Frank Li <Frank.Li@xxxxxxx> Applied, thanks!